Vszerda
Vszerda 33ft RP-SMA Male to Female Antenna Extension Cable
A 33 ft low-loss RP-SMA extension cable for Wi-Fi and cellular antennas, compliant with IEEE 802.11a/b/g/n and 50 ohm impedance
- ColorBlack
- 33 ft length lets you position antennas for best signal
- 50 ohm low-loss coaxial cable preserves wireless performance
- RP-SMA male to female connectors fit Wi-Fi routers and bridges
- Compatible with 2.4 GHz gear including 24 dBi antennas
- Built with pure copper oxidised joints for reliable conductivity
Vszerda 33ft RP-SMA Antenna Extension
This 33ft RP-SMA male to female extension cable connects wireless LAN routers, bridges, cellular antennas or security IP cameras to external antennas. It uses 50 ohm dedicated wireless engineering wire with pure copper oxidised connectors. The 10 metre length gives flexibility to position an antenna for optimal signal reception. It is designed specifically for Wi-Fi and cellular use, not for TV antennas.
IEEE 802.11 Compliance and Signal Integrity
The cable complies with IEEE 802.11a, b, g and n wireless LAN standards operating in the 2.4 GHz band. Low-loss construction helps maintain signal quality over the full 33ft run. Pure copper oxidised joints on the RP-SMA connectors ensure reliable electrical contact. The 50 ohm impedance matches typical wireless equipment requirements for efficient power transfer.
Sustained Link Performance Over Distance
Under continuous operation the 50 ohm cable maintains consistent attenuation characteristics for stable long-term links. The RP-SMA male to female interface stays secure without signal degradation during extended use. The 33ft length supports multilevel coverage setups with 24 dBi antennas or similar high-gain devices. It remains suited for permanent installations on routers, network adaptors or bridge equipment.
Highlights
- 33 ft length lets you position antennas for best signal
- 50 ohm low-loss coaxial cable preserves wireless performance
- RP-SMA male to female connectors fit Wi-Fi routers and bridges
- Compatible with 2.4 GHz gear including 24 dBi antennas
- Built with pure copper oxidised joints for reliable conductivity
Specifications
| Brand | CORONIR |
|---|---|
| Model | CORONIR |
| Part Number | C-10M |
| Color | Black |
Questions about this item
How do I install the 33ft RP-SMA extension cable and what connector mistake should I avoid?
Connect the RP-SMA male end to your router or wireless card and the RP-SMA female end to the antenna. The common error is confusing RP-SMA with standard SMA; check the pin and thread gender before tightening.
What maintenance will the 50 ohm coax cable and pure copper RP-SMA connectors need over time?
Inspect the connectors for oxidation or loosening every few months. Wipe the pure copper joints with a dry cloth and re-seat them if signal drops appear, but the cable itself requires no routine servicing.
At what cable length does signal loss become the limiting factor for sustained 2.4GHz Wi-Fi links?
The 33ft (10m) run of 50 ohm coax introduces measurable attenuation at 2.4GHz; beyond this length the loss typically outweighs the gain from better antenna placement.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
