We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Green circuit board with 40-pin IDE and SATA connectors

Vszerda

Vszerda 3.5" IDE 40Pin to SATA Adapter

SKU CH-WR5A-NH7XN

Connects a 3.5 inch IDE 40Pin drive up to 1000GB to a SATA motherboard without extra power

  • Connect 3.5" IDE drives up to 1000GB via 40-pin interface
  • Upgrade legacy systems using IDE 66/100/133MB/s transfer rates
  • Operate without additional power supply for simpler installation
  • Install instantly with plug-and-play across DOS, Windows 98/98SE, Me, 2000, 2003, XP, Vista, 7 & Linux
  • Convert 3.5" IDE/PATA 40-pin HDD to SATA female connector directly

IDE to SATA adapter for 3.5" drives

The Vszerda adapter connects a 3.5 inch IDE 40Pin hard disk drive to a SATA motherboard port. It supports IDE transfer rates of 66, 100 and 133 MB/s and works with drives up to 1000 GB capacity. The unit is designed for desktop systems and requires no extra power supply. No drivers are needed for operation across DOS, Windows 98 through Windows 7 and Linux.

Plug and play with no external power

The adapter draws power directly from the drive connection, removing the need for a separate power cable. Installation is a simple plug and play process, though the device is not hot swappable. Broad operating system compatibility covers legacy and older platforms including Windows 2000, 2003, XP and Vista. This allows immediate recognition without software configuration.

Suits legacy desktop upgrades

This adapter suits users upgrading an older desktop that has a SATA motherboard but retains a 3.5 inch IDE hard drive. It also fits builders moving to a SATA SSD or hard drive while keeping the existing IDE interface. Buyers who need hot swap capability should look elsewhere. Systems requiring 2.5 inch drive support or laptop IDE connectors are not addressed by this unit.

Highlights

  • Connect 3.5" IDE drives up to 1000GB via 40-pin interface
  • Upgrade legacy systems using IDE 66/100/133MB/s transfer rates
  • Operate without additional power supply for simpler installation
  • Install instantly with plug-and-play across DOS, Windows 98/98SE, Me, 2000, 2003, XP, Vista, 7 & Linux
  • Convert 3.5" IDE/PATA 40-pin HDD to SATA female connector directly

Specifications

No published specifications for this item yet.

Questions about this item

Will the IDE 40-pin connector or SATA interface need replacement after heavy use?

The adapter is a passive PCB with no moving parts; under normal desktop use neither the 40-pin IDE nor the SATA connector requires scheduled replacement.

What transfer-rate ceiling will I hit first when running large copies continuously?

The bridge tops out at the IDE 133 MB/s mode, so sustained throughput cannot exceed that limit regardless of the SATA drive speed.

Does the adapter add noticeable heat or noise when the system stays on all day?

No active components or fan are present, so the board adds negligible heat and zero audible noise during continuous operation.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.