We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Flat blue ribbon cable with straight 74-pin SFF-8654 connectors at both ends

Vszerda

Vszerda 24G SlimSAS SFF-8654 to SFF-8654 8i SAS 4.0 Cable 1m

SKU CH-FJZN-ZKWAA

Connects high-density NVMe or SAS devices at 24 Gbps with a straight 74-pin SlimSAS link

  • TypeInternal SlimSAS Cable
  • Color11#: Straight
  • Length1
  • Connector DetailSff-8654 to Sff-8654 8i
  • Terminal GenderMale-to-Male
  • Speed24 gigabits_per_second
  • 24 Gbps throughput for fast data transfers
  • 85 Ohm impedance and 32 AWG construction maintain signal quality
  • Straight SFF-8654 8i connectors fit high-density 74-pin ports
  • PCIe 4.0 and SAS 4.0 support enables modern server and storage builds
  • Lightweight 1 m ribbon design simplifies internal cable routing

What this cable is and who uses it

This Vszerda SlimSAS SFF-8654 cable connects 8i internal ports at 24Gbps. It is built for high-density servers, workstations and data-centre storage arrays that need a 1m, 85-ohm, 32AWG ribbon link with straight 74-pin plugs. The assembly meets the T10 Serial Attached SCSI standard and is extended for PCIe 4.0 transport.

Who it suits and who should look elsewhere

Installers working with SFF-8654 8i sockets in tight chassis will appreciate the low-profile ribbon design. Builders who need a different connector pitch, an angled plug variant or an external bulkhead interface cannot use this part. The fixed 1m length also rules out runs that require shorter or longer reach.

The spec that decides fit

The single decisive figure is the 24Gbps data rate combined with the SFF-8654 8i male-to-male interface. If your backplane or controller specifies that exact connector and speed, this cable matches; otherwise it will not connect or perform as required.

Highlights

  • 24 Gbps throughput for fast data transfers
  • 85 Ohm impedance and 32 AWG construction maintain signal quality
  • Straight SFF-8654 8i connectors fit high-density 74-pin ports
  • PCIe 4.0 and SAS 4.0 support enables modern server and storage builds
  • Lightweight 1 m ribbon design simplifies internal cable routing

Specifications

Brandipolex
TypeInternal SlimSAS Cable
Color11#: Straight
Length1
Connector DetailSff-8654 to Sff-8654 8i
Terminal GenderMale-to-Male
Speed24 gigabits_per_second
SpecificationsInternal SlimSAS Cable
ShieldingData Transfer, High Speed, Lightweight,etc.
FeaturesData Transfer, High Speed, Lightweight,etc.

Questions about this item

Will the 32AWG conductors on this 85-ohm SlimSAS cable need periodic replacement in a server rack?

The 32AWG ribbon construction is rated for continuous internal use; no scheduled conductor replacement is required unless physical damage occurs during maintenance.

At sustained 24Gbps throughput, does the 1-metre length hit a signal-integrity limit before the controller does?

The 85-ohm impedance and 74-pin high-density design maintain signal integrity across the full 1-metre run at 24Gbps, so the controller typically reaches its own queue-depth ceiling first.

Does the unshielded 11# straight plug run hotter or noisier than shielded alternatives when the link stays up 24/7?

The cable is passive copper with no active components, so it generates no audible noise and negligible heat regardless of continuous duty cycle.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.