Vszerda
Vszerda 2 Pcs RJ45 1-to-2 Ethernet Splitter Adapter Black Aluminium Alloy network connector
Splits one Ethernet port into two for paired-device networking at up to 100 Mbps over Cat5e/Cat6/Cat8 cables
- Requires paired use for dual-device connectivity
- Extends cable reach up to 100 metres
- 100 Mbps transmission without delay
- Compatible with Cat5e Cat6 Cat8 networks
- Aluminium alloy shell resists fingerprints scratches
Paired RJ45 splitter for two devices
This two-piece RJ45 splitter kit lets you share a single Ethernet port between two devices when both adapters are installed at opposite ends of the link. Each unit provides one female port that splits into two female ports, accepting Cat5e, Cat6 or Cat8 patch cables. The aluminium alloy housing resists fingerprints and scratches while keeping the RJ45 connections secure.
100 Mbps limit under continuous use
Because the 1-to-2 wiring uses only four conductors per output, the link negotiates at 100 Mbps rather than gigabit speeds, and this rate holds steady over runs up to 100 metres. The adapter simply extends the existing cable without adding latency, so sustained transfers stay consistent within the 100 megabit ceiling.
Check that you can deploy both ends
You must install one splitter at the switch or router side and the second at the device side; a single unit will not allow two devices to operate simultaneously. Verify that both locations have a free RJ45 jack and that 100 Mbps bandwidth meets the needs of the connected equipment before ordering.
Highlights
- Requires paired use for dual-device connectivity
- Extends cable reach up to 100 metres
- 100 Mbps transmission without delay
- Compatible with Cat5e Cat6 Cat8 networks
- Aluminium alloy shell resists fingerprints scratches
Specifications
No published specifications for this item yet.
Questions about this item
Does the aluminium-alloy housing keep the splitter cool when it runs all day?
The passive aluminium-alloy case has no fan or heatsink; it simply dissipates the tiny heat from a 100 Mbps signal and stays at room temperature during continuous use.
What cables and paired unit do I need so the two ports work together?
You must use two splitters — one at each end of a single Cat5e, Cat6 or Cat8 patch cable — so each device gets its own four-wire path.
Will my Cat6a or Cat8 patch cords still plug in and run at 100 Mbps?
Yes, the RJ45 ports accept Cat5e, Cat6 and Cat8 plugs; the internal wiring limits each port to 100 Mbps regardless of cable category.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
