We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two black-sleeved splitter cables with Molex and 3-pin or 4-pin fan connectors

Vszerda

Vszerda 2 Pack Molex to 3 Pin 4 Pin Fan Power Splitter Adapter Cable 10 inch

SKU CH-PKN8-0176V

Two 10 inch cables split one Molex connector to power up to two 3-Pin or 4-Pin case fans with black sleeving

  • Powers two 3-pin or 4-pin fans from one Molex connector
  • Fixed 12 V operation works with 2-pin Molex design
  • 6 inch cable length suits compact builds
  • High-density black sleeving gives a clean all-black look
  • Pack of two splitters adds cooling flexibility

Two Molex-to-fan splitter cables

This twin-pack connects up to two 3-pin or 4-pin case fans to a single Molex power connector. Each cable measures 27 cm excluding the connectors and is wrapped in high-density black sleeving for a uniform look. The Molex plug carries only the two pins required for a fixed 12 V supply. Builders adding extra chassis airflow can use these adapters without occupying motherboard headers.

Suits Molex-powered fan installs

The pair is ideal for systems with spare Molex leads but limited fan headers on the board. It will not help builders who need PWM speed control from the motherboard, because the Molex feed supplies constant 12 V. Buyers wanting voltage-regulated or software-controlled fan curves should look at motherboard-connected alternatives instead.

Fixed 12 V Molex feed

The defining specification is that the Molex connector delivers a steady 12 V through two active pins. This means both attached fans run at full speed continuously, with no option for speed reduction via the adapter itself. If constant maximum airflow is acceptable, the cables are a direct fit; if variable speed is required, this power source will not provide it.

Highlights

  • Powers two 3-pin or 4-pin fans from one Molex connector
  • Fixed 12 V operation works with 2-pin Molex design
  • 6 inch cable length suits compact builds
  • High-density black sleeving gives a clean all-black look
  • Pack of two splitters adds cooling flexibility

Specifications

No published specifications for this item yet.

Questions about this item

Will the 10.6 inch cable reach from my PSU Molex connector to two case fans in a mid-tower?

The 27 cm lead (10.6 inch excluding connectors) spans typical mid-tower distances from a PSU Molex plug to two 3-pin or 4-pin fan headers.

Do I need to align any keyed pins when plugging the 4-pin Molex end into my power supply?

The Molex plug is a standard 4-pin housing with only two active pins; insert it with the chamfered corners facing the correct way — it only fits one orientation.

Will the black sleeving degrade if the fans run at 12 V continuously?

The high-density black sleeving is rated for the fixed 12 V Molex voltage and normal case-fan currents, so it does not require periodic replacement.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.