We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two ATX power switch cables with red and green LEDs and momentary buttons, 27-inch length

Vszerda

Vszerda 2-Pack ATX Power Switch Cable 2-Pin 27-inch

SKU CH-3B41-1TKEK

Two 27-inch ATX power-switch cables with red and green LEDs for case front-panel replacement or mining-rig power control

  • Two-pack provides a spare or dual-system setup
  • 27-inch cables reach most front-panel headers
  • Red and green LEDs show power and drive activity
  • Labeled connectors simplify motherboard installation
  • Replaces damaged power or reset switches on ATX cases

Vszerda ATX Power Switch Cable 2-Pack

This 2-pack supplies two 27-inch ATX power switch cables for desktop cases and motherboards with standard 2-pin front-panel headers. Each cable includes labeled Power SW, Reset SW, Power LED, and HDD LED connectors plus red and green indicator LEDs. Builders replacing a broken switch or adding external power control to a mining rig will find the parts ready to install.

Sustained daily operation

The momentary push-button switches and LED indicators are rated for repeated actuation over the life of a typical desktop build. Cable insulation and connector crimps maintain reliable contact through frequent power cycles and system resets. No active cooling or thermal management is required because the assembly carries only low-voltage signalling current.

27-inch cable length

At 27 inches the leads reach most mid-tower and full-tower front-panel header locations without stretching or excess slack. Shorter cables may not span the distance in larger chassis, while longer runs can obstruct airflow or cable routing. Verify the motherboard header position before ordering.

Highlights

  • Two-pack provides a spare or dual-system setup
  • 27-inch cables reach most front-panel headers
  • Red and green LEDs show power and drive activity
  • Labeled connectors simplify motherboard installation
  • Replaces damaged power or reset switches on ATX cases

Specifications

No published specifications for this item yet.

Questions about this item

Does the 27-inch cable add any noticeable heat or power draw when the system runs continuously?

The cable is a passive 2-pin switch assembly with two small LEDs; it draws only the tiny current needed to light the red and green indicators and adds no measurable heat.

What motherboard header must already be present for the 2-pin plugs to connect?

You need a standard 2-pin front-panel header on the motherboard for Power SW, Reset SW, Power LED+/- and HDD LED+/- connections.

Will the 68 cm leads reach the front-panel header on an older ATX board with the header near the rear edge?

At 68 cm the cables are long enough to route from a front bezel to headers positioned at the back of most legacy ATX motherboards.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.