Innovation First, Inc. 1UCMA-137 1U Cable Management Arm 19" 28.5"-33" computer accessory
- Product Type:Cable…
- Panel Width:19" Rac…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Vszerda
Two right-angle 19/20-pin adapters route internal USB 3.0 cables up or down at 90 degrees for 5 Gbps transfer while reducing strain and clutter
The Vszerda two-pack supplies one upward-angled and one downward-angled 19/20-pin adapter that plugs between a motherboard header and a front-panel USB 3.0 cable. Each L-shaped connector removes the need to bend thick internal cables, reducing strain on the header and tidying cable routing behind the motherboard tray. The ABS housing is lightweight and dust-resistant. Builders working in tight chassis or around bulky fan shrouds gain a cleaner internal layout.
A standard straight plug forces the USB 3.0 cable into a sharp bend that can stress the motherboard pins and block airflow. The angled adapters reroute the cable parallel to the board, so the upgrade is worthwhile whenever the header sits close to a graphics card, power connector or case wall. If the current cable already reaches without tension or the header is fully exposed, the adapter adds no benefit. The two orientations cover most header rotations found on modern desktop boards.
The adapter passes the full USB 3.0 signalling rate of 5 Gbps, ten times the 2.0 ceiling, and supports simultaneous bi-directional transfer. Headroom is sufficient for any front-panel USB 3.0 port, including high-speed flash drives and external SSDs. It does not add bandwidth beyond the header specification, so devices that require USB 3.1 or 3.2 speeds will operate at the 3.0 limit. The solid ABS body resists deformation, but the maker warns against pulling the adapter straight out after installation to avoid pin damage.
No published specifications for this item yet.
Yes, the male end plugs straight into the board's 19/20-pin USB 3.0 header; the 90-degree bend lets the cable run parallel to the board instead of sticking out.
Check the header's position relative to nearby components — use the up-angle if the cable must route upward, the down-angle if it must route downward — and insert the adapter gently without forcing the pins.
The ABS shell is dust-resistant and rated for long-term use; it does not require scheduled replacement unless physical damage occurs during removal.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
No language matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?