We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two silver metal 2.5-inch drive caddies with screw holes

Vszerda

Vszerda 2.5" SAS/SATA Hard Drive Tray Caddy 0DXD9H 2-Pack

SKU CH-2S1M-P2PR2

Metal caddy holds two 2.5-inch SAS or SATA drives in Dell PowerEdge 14th, 15th and 16th generation servers

  • Dimensions16.7 in x 9.3 in x 2.3 in
  • Package Contentsno
  • Fits 2.5" SAS or SATA drives into 3.5" bays
  • Metal bracket keeps drives secure in Dell PowerEdge servers
  • Compatible with 14th 15th 16th generation PowerEdge models
  • Two caddies plus eight mounting screws included
  • 57 x 3.66 x .91 inches per tray

2.5" SAS/SATA Server Caddy

This Vszerda tray caddy converts a 2.5 inch SAS or SATA drive to fit the 3.5 inch bay spacing found in Dell PowerEdge 14th, 15th and 16th generation servers. The metal bracket ships as a two-pack with eight mounting screws included. It is built for administrators who need to populate hot-swap bays with solid-state or mechanical 2.5 inch media.

Upgrade From 3.5" Drives

The caddy lets you replace legacy 3.5 inch hard drives with faster 2.5 inch SAS or SATA SSDs without changing the server chassis. The jump is worth it when you need lower latency, reduced power draw or higher drive density in the same rack unit. It also supports mixed SSD and HDD deployments across R440, R640, R740, R740xd, R840, R940 and newer PowerEdge models.

Check Bay Type And Drive Height

Verify that your server uses the standard 3.5 inch hot-swap carrier format and that the 2.5 inch drives you plan to install are no thicker than the caddy's internal clearance. Confirm the part number 0DXD9H matches your system's service manual before ordering. The bracket is not compatible with proprietary blade enclosures or non-Dell chassis.

Highlights

  • Fits 2.5" SAS or SATA drives into 3.5" bays
  • Metal bracket keeps drives secure in Dell PowerEdge servers
  • Compatible with 14th 15th 16th generation PowerEdge models
  • Two caddies plus eight mounting screws included
  • 57 x 3.66 x .91 inches per tray

Specifications

BrandHeretom
Dimensions16.7 in x 9.3 in x 2.3 in
Package Contentsno

Questions about this item

What drive form factor and interface does the 0DXD9H tray accept?

The tray holds a single 2.5-inch SAS or SATA drive and presents a 3.5-inch form factor to the server bay.

Which screws and orientation are used to mount a drive into the metal caddy?

Eight mounting screws are included; attach them through the four side holes on each tray so the drive connector faces the rear of the server.

How often should the tray be inspected or replaced in a PowerEdge R740?

The metal bracket is designed for the life of the server; inspect only if physical damage occurs during drive swaps.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.