We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small green circuit board with 44-pin IDE connector and SATA port

Vszerda

Vszerda 2.5" IDE 44-Pin to SATA Adapter

SKU CH-RM2E-Q1VTD

Converts a 2.5" IDE 44-pin drive to SATA for laptop upgrades up to 500 GB, plug-and-play with no extra power needed

  • Upgrade old laptops with modern 2.5" SATA drives
  • No extra power supply needed for installation
  • Plug-and-play operation without driver installation
  • Supports IDE 44-pin drives up to 500GB capacity
  • Compact 69mm x 14mm x 17mm board fits tight spaces

Vszerda 2.5" IDE to SATA Adapter

This adapter converts a 2.5 inch IDE 44-pin hard drive or SSD to a SATA interface for use with a SATA motherboard port. It targets owners of legacy laptops or embedded systems who want to replace an ageing IDE drive with a modern SATA unit without rewiring the chassis. No external power supply or driver installation is required for operation.

IDE 66/100/133 MB/s Throughput Limit

The board passes through the native IDE 66, 100 and 133 MB/s signalling rates, so the SATA drive will operate at the host bus ceiling rather than its own higher potential. Hot-swap capability is absent, meaning the system must be powered down before the drive is connected or removed. Compatibility spans DOS, Windows 98 through Windows 7 and Linux, covering most vintage and contemporary operating systems still found on 2.5 inch IDE platforms.

Compact PCBA With 40-Pin Host Connector

The converter measures 69 mm by 14 mm by 17 mm, fitting inside tight 2.5 inch drive bays and caddies. A 40-pin male header mates directly with the motherboard IDE socket while a SATA female receptacle accepts the replacement drive. The plug-and-play design simplifies field upgrades but requires a shutdown cycle for every drive change.

Highlights

  • Upgrade old laptops with modern 2.5" SATA drives
  • No extra power supply needed for installation
  • Plug-and-play operation without driver installation
  • Supports IDE 44-pin drives up to 500GB capacity
  • Compact 69mm x 14mm x 17mm board fits tight spaces

Specifications

No published specifications for this item yet.

Questions about this item

Which capacity limit should I check before buying this IDE-to-SATA adapter?

The adapter supports IDE 44-pin drives up to 500 GB, so confirm your drive does not exceed that size.

What real-world transfer rate can I expect once the adapter is installed?

It supports IDE 66, 100 and 133 MB/s modes; actual throughput will be limited by the drive and the host controller.

Does the 44-pin IDE interface carry power, or do I need a separate supply?

The 44-pin connector supplies power to the 2.5-inch drive, so no extra power cable is required.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.