We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Green circuit board with black 40-pin IDE connector and SATA data power ports

Vszerda

Vszerda 2.5/3.5" SATA to IDE 40Pin Hard Drive Adapter

SKU CH-5N4A-9S3HC

Connects 2.5 or 3.5 inch SATA drives to 40 pin IDE motherboards with master/slave jumper and plug-and-play setup

  • Connect 2.5 or 3.5" SATA drives to legacy IDE 40-pin motherboards
  • Supports IDE 66, 100 and 133 MB/s transfer modes
  • Master/slave jumper configures drive priority on the IDE channel
  • Driver-free plug-and-play operation across DOS, Windows 98 through 10 and Linux
  • Upgrade older systems by replacing IDE HDDs with modern SATA HDDs or SSDs

SATA-to-IDE 40-pin converter board

This adapter connects a 2.5 or 3.5 SATA drive to a motherboard IDE 40-pin header. It supports IDE transfer modes at 66, 100 and 133 MB/s. A master and slave jumper is included on the board. No driver installation is required for the listed operating systems.

Check motherboard header and power before fitting

Verify the board provides a standard IDE 40-pin connector and a spare Molex or floppy power lead for the adapter. The unit is not hot swappable, so power down the system before connecting or removing the drive. Ensure the jumper is set to the correct master or slave position for your cable layout.

Sustained throughput matches legacy IDE limits

Under continuous read or write workloads the adapter delivers the rated IDE 66, 100 or 133 MB/s ceiling. Performance is bounded by the host IDE controller rather than the SATA drive itself. The board adds no active cooling, so airflow across the PCB is sufficient for long-term operation.

Highlights

  • Connect 2.5 or 3.5" SATA drives to legacy IDE 40-pin motherboards
  • Supports IDE 66, 100 and 133 MB/s transfer modes
  • Master/slave jumper configures drive priority on the IDE channel
  • Driver-free plug-and-play operation across DOS, Windows 98 through 10 and Linux
  • Upgrade older systems by replacing IDE HDDs with modern SATA HDDs or SSDs

Specifications

No published specifications for this item yet.

Questions about this item

Does the adapter include a SATA data cable or power cable, or must I supply them separately?

The package contains only the converter board with a 40-pin IDE connector and a master/slave jumper; SATA data and power cables are not included and must be provided by the user.

Should I choose the 40-pin or 44-pin version for a standard desktop IDE motherboard header?

The 40-pin version matches the standard desktop IDE header; the 44-pin variant is intended for 2.5-inch laptop drives and is not required for a typical 3.5-inch motherboard connection.

Will the quoted 133 MB/s IDE transfer rate be reached when a modern SATA SSD is connected through this board?

The adapter supports IDE modes up to 133 MB/s, but actual throughput is limited by the host IDE controller and the drive's own SATA speed, so the headline figure is a ceiling rather than a guarantee.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.