Vszerda
Vszerda 15Pin Male to 2 Female 90 degree SATA Power Cable Adapter 20cm internal power cable
Splits one SATA power connector into two with 90-degree ends for tight builds, 20cm long
- Splits one SATA power connector into two drives
- 90-degree male plug routes cable cleanly in tight cases
- 20 cm length reaches adjacent bays without slack
- 15-pin SATA interface matches standard drive power ports
- New cable ready for immediate installation
SATA Power Splitter for Dual Drives
This 15-pin male to dual female SATA power adapter adds a second drive connection from a single PSU lead. The 90-degree plug eases routing behind motherboards or drive cages in compact builds. It suits anyone expanding storage without a modular cable swap. The 20 cm length keeps the daisy chain short inside small cases.
When One SATA Lead Falls Short
Use this splitter when the power supply lacks enough native SATA connectors for every SSD or hard drive. The right-angle head clears tight side-panel gaps where straight plugs would press against metal. The gain is worth it whenever cable count, not wattage, is the limiting factor. No extra rails or adapters are required beyond the existing SATA output.
Steady Current Through the Y-Split
Both female ports share the single 15-pin source, so total draw stays within the PSU connector rating. The 20 cm conductors add negligible resistance under continuous drive spin-up and seek cycles. Heat stays low because the wire gauge matches standard SATA power specs. Mechanical strain is reduced by the 90-degree bend during long-term vibration.
Highlights
- Splits one SATA power connector into two drives
- 90-degree male plug routes cable cleanly in tight cases
- 20 cm length reaches adjacent bays without slack
- 15-pin SATA interface matches standard drive power ports
- New cable ready for immediate installation
Specifications
No published specifications for this item yet.
Questions about this item
What clearance does the 90 degree SATA connector need behind the drive?
The right-angle plug extends about 20 cm from the drive, so allow at least that much depth behind the SATA port for the cable to bend without stress.
How do I connect the splitter so both drives receive power reliably?
Insert the 15-pin male end into the PSU SATA connector until it clicks, then attach each 15-pin female end to a drive; the keyed design prevents reversed insertion.
When should I replace this 20 cm SATA power splitter?
Replace it if the 15-pin contacts show discoloration, the insulation cracks near the 90 degree bend, or either drive loses power intermittently.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Black Box Corporation
Black Box Corporation CAT6 EZ-RJ45 Modular Plugs 100-Pack
$95.99
0.00114821BTC
In stock
