We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

Vszerda

Vszerda 12VHPWR ATX 3.0 PCIe 5.0 90° Down Extension Cable 17cm

SKU CH-ETJB-SJSQJ

A 17 cm, 16 AWG male-to-female extension with a 90° down-angled 12VHPWR connector rated for 600 W under ATX 3.0 and PCIe 5.0

  • 90° down angle eases routing in tight cases
  • 17 cm length keeps cable runs short and tidy
  • 16 AWG conductors support up to 600 W delivery
  • ATX 3.0 PCIe 5.0 12VHPWR connector fits RTX 40 and RDNA 3 cards
  • 12+4 pin layout provides power and signal in one plug

12VHPWR ATX 3.0 Extension Cable

This 17 cm male-to-female extension adds a 90-degree downward angle to the 12VHPWR connection. It is built for builders routing power to PCIe 5.0 graphics cards in tight chassis layouts. The 16 AWG conductors support the full 600 W rating defined by the ATX 3.0 specification.

600 W delivery with 16 AWG wires

The cable carries up to 600 W through twelve power pins and four signal pins, matching the PCI-SIG 12VHPWR H+ standard. It comfortably handles RTX 40-series and RDNA 3 cards such as the 3080 and 3090TI. The short 17 cm length limits reach, so it suits only builds where the PSU connector sits close to the graphics card socket.

90-degree downward plug orientation

The fixed 90-degree down angle clears side panels and cable-routing channels that a straight connector would hit. Builds needing an upward, left or right exit cannot use this cable. No alternative angle or straight version is included in this package.

Highlights

  • 90° down angle eases routing in tight cases
  • 17 cm length keeps cable runs short and tidy
  • 16 AWG conductors support up to 600 W delivery
  • ATX 3.0 PCIe 5.0 12VHPWR connector fits RTX 40 and RDNA 3 cards
  • 12+4 pin layout provides power and signal in one plug

Specifications

No published specifications for this item yet.

Questions about this item

Will this 90° down extension cable clear the side panel on a compact case with an RTX 3080 or 3090 Ti installed?

The 17 cm length and 90° down angle route the 12VHPWR connector close to the card edge, reducing the depth needed behind the graphics card in tight builds.

How can I verify the 12+4 pin connector is fully seated and delivering up to 600 W after installation?

Push both male and female ends until the latch clicks, then confirm the GPU powers on and shows stable 12 V rails under load in monitoring software.

Does the package include any 8-pin to 12VHPWR adapters or extra mounting clips?

Only the 16 AWG male-to-female 12VHPWR extension cable is supplied; adapters and clips are not included.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.