We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black 90-degree 12+4 pin power bridge, 23 mm low-profile PCB adapter

Vszerda

Vszerda 12VHPWR 12+4 Pin 90° Power Bridge Black

SKU CH-J74D-Q5PCN

A 12VHPWR 12+4 pin 90° power bridge extending 23mm for PCIe 5.0 graphics cards up to 450W

  • 90° angle clears tight side panels with only 23 mm depth
  • Strengthened PCB keeps all 12+4 pins fully seated without wire bends
  • Rated for 450 W continuous delivery to supported GPUs
  • PCIe 5.0 interface for modern graphics cards
  • Low-profile design adds just 23 mm for compact chassis clearance

12VHPWR 90° power bridge

The Vszerda adapter connects 12+4 pin GPU power cables at a right angle. A strengthened PCB carries the connection without wire bending, keeping full terminal contact. The low-profile design extends 23 mm from the card edge. It is rated for 450 W maximum power output.

Compact builds and side-panel clearance

Builders with limited space between the graphics card and the side panel gain the 23 mm clearance needed to close the case. The 90° orientation suits larger chassis where cable routing flexibility is preferred. Buyers whose cards need a straight or 180° connector should look at the other variant. Cases without at least a 23 mm gap cannot use this adapter.

450 W power limit

The adapter is specified for a maximum of 450 W. Systems drawing more power through the 12VHPWR connection risk overheating and component damage. Adequate case ventilation is required to maintain safe temperatures at this load.

Highlights

  • 90° angle clears tight side panels with only 23 mm depth
  • Strengthened PCB keeps all 12+4 pins fully seated without wire bends
  • Rated for 450 W continuous delivery to supported GPUs
  • PCIe 5.0 interface for modern graphics cards
  • Low-profile design adds just 23 mm for compact chassis clearance

Specifications

No published specifications for this item yet.

Questions about this item

How do I fit the 90° 12+4 pin bridge onto my GPU and what clearance mistake should I avoid?

Connect the adapter to the card's 12+4 pin socket so the 90° bend directs the cable toward the side panel; confirm at least 23 mm of space remains between the panel and the graphics card before closing the case.

What upkeep will the power bridge need after it is installed?

No scheduled maintenance is required; periodically check that the connector stays fully seated and that dust does not block airflow around the 23 mm low-profile body.

What is the first limit I will hit if I run the adapter at full load for a long time?

The bridge is rated for a maximum of 450 W; sustained loads above that level will cause overheating before any other issue appears.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.