We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black PWM fan hub with 16-inch cable splitting one 4-pin connector into five

Vszerda

Vszerda 1-to-5 PWM Fan Hub 16-Inch Cable

SKU CH-G9SA-SD9SW

Splits one four-pin fan header into five PWM connectors with a 16-inch lead for flexible routing

  • Expand to five fans from one 4-pin header
  • All five fans run at identical PWM speed
  • Works with any standard desktop 4-pin fan header
  • 16-inch cable allows flexible routing inside the case
  • Black nylon sleeve and double-sided tape for clean cable management

Five-Fan PWM Hub

This 1-to-5 PWM fan hub expands a single four-pin motherboard header into five fan connections for custom PC builds. The hub draws power through one connector and distributes it to all five outputs. A 16-inch lead from the motherboard plug to the hub gives flexible routing inside the case. Black nylon sleeving and included double-sided tape keep the installation tidy.

Sustained Operation

All five connected fans run at identical speeds governed by the PWM signal from the first fan attached to the hub. The splitter delivers consistent power to each output during continuous use without introducing speed variance between fans. The four-pin design maintains pulse-width control across the full operating range. No additional power source is required beyond the motherboard header.

Single Header Constraint

Builders with only one available four-pin fan header can connect up to five fans using this hub. Systems that need independent speed curves for each fan cannot use this hub because all outputs share one PWM signal. The 16-inch lead length determines maximum placement distance from the motherboard header. Users requiring more than five fan connections need an additional hub or controller.

Highlights

  • Expand to five fans from one 4-pin header
  • All five fans run at identical PWM speed
  • Works with any standard desktop 4-pin fan header
  • 16-inch cable allows flexible routing inside the case
  • Black nylon sleeve and double-sided tape for clean cable management

Specifications

No published specifications for this item yet.

Questions about this item

How much power does the 1-to-5 PWM fan hub draw when all five fans run continuously?

The hub passes power from the single motherboard header to all five fans; total draw equals the combined rating of the connected fans and must stay within the header’s current limit.

What must my motherboard provide for this hub to work?

One standard four-pin PWM fan header is required; the hub splits that header into five connectors and includes double-sided tape for mounting.

Will the 16-inch cable reach a rear-mounted header in a full-tower case while keeping the hub near the front fans?

The 16-inch lead from motherboard connector to hub gives enough length to route behind the motherboard tray and position the hub close to front or top fans.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.