We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small brass straight shut-off valve with sweat and compression ends

Vintage

Vintage CC83255X 1/2" Sweat 3/8" O.D. Comp Straight Shut-off Valve

SKU CH-8T76-2R6P8

1/2" sweat to 3/8" O.D. compression straight shut-off valve for bath faucet supply lines

  • TypeTools
  • Straight shut-off valve controls water flow at the fixture
  • 1/2 inch sweat inlet solders directly to copper supply lines
  • 3/8 inch O.D. compression outlet connects supply tubes without threading
  • Vintage brand plumbing component supplied new for installation
  • California Proposition 65 warning indicates regulated chemical content

1/2" Sweat Straight Shut-off Valve

This Vintage CC83255X valve connects 1/2" sweat copper piping to 3/8" O.D. compression fittings. It provides a straight in-line shut-off point for bath supply lines. The body is intended for residential plumbing installations. California Proposition 65 warnings apply.

3/8" O.D. Compression Outlet

The compression end accepts 3/8" outside diameter supply tubes commonly used on faucets and toilets. The sweat inlet requires soldering to copper pipe for a permanent joint. No additional adapters are included in the package.

In-line Installation Requirements

The straight pattern keeps the supply line in a single plane, simplifying routing in tight cavities. Soldering tools and flux are needed for the sweat connection. The valve frees the installer from using a separate coupling and elbow combination.

Highlights

  • Straight shut-off valve controls water flow at the fixture
  • 1/2 inch sweat inlet solders directly to copper supply lines
  • 3/8 inch O.D. compression outlet connects supply tubes without threading
  • Vintage brand plumbing component supplied new for installation
  • California Proposition 65 warning indicates regulated chemical content

Specifications

BrandVINTAGE
TypeTools

Questions about this item

Will the 1/2" sweat inlet connect to my existing copper supply lines?

Yes, the sweat inlet is sized for standard 1/2" copper pipe and is joined by soldering for a permanent, leak-free connection.

How can I confirm the valve is operating correctly after installation?

Turn the handle through its full range; water should flow freely when open and stop completely when closed with no drips at the 3/8" compression outlet.

Does the package include the compression nut and ferrule for the 3/8" outlet?

The valve body is supplied; a 3/8" compression nut and ferrule are typically sold separately if not already on your supply tube.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.