We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Vintage angle stop valve with handle, chrome finish

Vintage

Vintage CC53301TL 5/8" X 3/8" OD Comp Angle Stop

SKU CH-SAKW-5D2PX

A 5/8 inch by 3/8 inch OD compression angle stop controls water flow to fixtures

  • TypeTools
  • 5/8" inlet fits standard supply lines
  • 3/8" OD compression outlet connects tubing without soldering
  • Angle stop design shuts off flow at the fixture
  • Quarter-turn handle allows quick on/off control
  • New Vintage CC53301TL unit ready for installation

Vintage CC53301TL Angle Stop

The Vintage CC53301TL is a compression angle stop valve designed for residential plumbing shut-off points. It connects a 5/8 inch supply line to a 3/8 inch outlet using compression fittings. The valve includes a handle for manual flow control and is supplied new for installation in bath faucet systems.

Sustained Load Behaviour

Under continuous household water pressure the brass body and compression seats maintain a reliable seal without degradation. The handle mechanism operates smoothly through repeated open and close cycles typical of daily fixture use. No performance change is expected over the normal service life of the fitting.

Installation Checks

Verify that the existing supply line measures 5/8 inch outside diameter and that the fixture inlet accepts a 3/8 inch compression connection. Confirm adequate clearance behind the fixture for the valve body and handle rotation. Ensure local plumbing codes permit compression angle stops in the intended location.

Highlights

  • 5/8" inlet fits standard supply lines
  • 3/8" OD compression outlet connects tubing without soldering
  • Angle stop design shuts off flow at the fixture
  • Quarter-turn handle allows quick on/off control
  • New Vintage CC53301TL unit ready for installation

Specifications

BrandVINTAGE
TypeTools

Questions about this item

Does the 5/8" OD compression angle stop run hot or make noise during continuous water flow?

It is a passive brass valve with no moving electrical parts, so it generates no heat and produces no audible noise under normal supply pressure.

What existing supply line and fitting sizes must I already have for the 5/8" x 3/8" OD compression connections?

You need a 5/8" OD copper or supply tube on the inlet side and a 3/8" OD tube or riser on the outlet side, each with matching compression nuts and ferrules.

Will the CC53301TL angle stop thread onto older 1/2" nominal copper stub-outs without an adapter?

The inlet uses a 5/8" OD compression seat, which fits 1/2" nominal copper tube directly; no adapter is required for that standard size.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.