We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small brass angle stop valve with slip joint connection

Vintage

Vintage CC44108KL 1/2" IPS X 1/2" X 7/16" Slip Joint Angle Stop

SKU CH-2TV1-P5F03

Connects 1/2 inch IPS supply to 1/2 inch and 7/16 inch slip-joint fixtures with an angle stop valve

  • TypeTools
  • 1/2" IPS inlet fits standard supply lines
  • 1/2" outlet connects to common fixtures
  • 7/16" slip joint seals without soldering
  • Angle-stop design shuts off water at the fixture
  • New Vintage part ready for installation

Vintage Slip-Joint Angle Stop

This Vintage CC44108KL slip-joint angle stop connects a 1/2 inch IPS supply to a 1/2 inch by 7/16 inch outlet. It is a new plumbing component designed to control water flow to a fixture such as a toilet or faucet. The part carries a California Proposition 65 warning regarding chemicals known to cause cancer and reproductive harm.

Installers Needing Quarter-Turn Shut-Off

The angle stop suits plumbers and DIYers replacing a straight or angled supply valve with a slip-joint connection. It is not for systems requiring a compression, push-fit, or sweat inlet, nor for installations needing a quarter-turn ball mechanism or a loose-key operator. Builders working on high-pressure commercial mains should verify pressure ratings before use.

1/2 Inch IPS Inlet Connection

The defining specification is the 1/2 inch IPS inlet that mates with iron-pipe-size threads on the supply stub-out. If the existing supply uses a different thread standard or connection type, this stop will not seal correctly. Match the inlet to the pipe to ensure a leak-free installation.

Highlights

  • 1/2" IPS inlet fits standard supply lines
  • 1/2" outlet connects to common fixtures
  • 7/16" slip joint seals without soldering
  • Angle-stop design shuts off water at the fixture
  • New Vintage part ready for installation

Specifications

BrandVINTAGE
TypeTools

Questions about this item

How much power does the 1/2" IPS angle stop draw when running all day?

The Vintage CC44108KL is a purely mechanical brass valve with no electrical components, so it consumes zero power and generates no heat or noise during continuous operation.

Which supply line and compression nut must I already have to install the 7/16" slip-joint outlet?

You need a 7/16" OD compression supply line (typically 1/4" nominal) with its matching ferrule and nut, plus a 1/2" IPS threaded inlet connection on the existing stop valve or stub-out.

Will the 1/2" IPS inlet thread seal reliably on older galvanised or brass stub-outs?

Yes, the 1/2" IPS male thread follows standard NPT dimensions, so it mates cleanly with legacy 1/2" female iron-pipe threads on galvanised, brass or copper stub-outs when sealed with PTFE tape or pipe dope.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.