We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Vintage angle stop valve brass finish 1/2 FIP slip joint connections

Vintage

Vintage CC44102TL 1/2 FIP 1/2 7/16 Slip Joint Angle Stop

SKU CH-4EGJ-NP6C4

Connects 1/2 inch FIP supply lines to 1/2 inch and 7/16 inch slip-joint outlets for angle-stop installations

  • TypeTools
  • 1/2" FIP inlet fits standard supply lines
  • 1/2" & 7/16" slip-joint outlets suit common fixtures
  • Angle-stop design allows local shut-off
  • Vintage brand built for plumbing reliability
  • New condition ready for immediate installation

Bathroom Angle Stop Valve

This quarter-turn angle stop connects a 1/2-inch FIP supply line to a 1/2-inch and 7/16-inch slip-joint outlet. It is designed for residential bathroom fixture installations where a compact shut-off point is required. The Vintage CC44102TL model provides a straightforward connection for sink or toilet supply stops.

Slip Joint Connection Limits

The slip-joint outlet relies on a compression nut and ferrule to seal against the supply tube, so the tubing must be clean, round and free of deep scratches. Over-tightening can distort the ferrule and cause weeping, while under-tightening leaves a leak path. The 1/2-inch FIP inlet requires pipe thread sealant or tape for a reliable joint.

Proposition 65 Chemical Notice

This product contains a chemical identified under California Proposition 65 as known to cause cancer and birth defects or other reproductive harm. Installers should wear gloves and wash hands after handling the valve. Buyers who need a certified lead-free or chemical-free component for potable water systems should verify compliance before purchase.

Highlights

  • 1/2" FIP inlet fits standard supply lines
  • 1/2" & 7/16" slip-joint outlets suit common fixtures
  • Angle-stop design allows local shut-off
  • Vintage brand built for plumbing reliability
  • New condition ready for immediate installation

Specifications

BrandVINTAGE
TypeTools

Questions about this item

Should I choose the CC44102TL angle stop or another version for my supply line?

The CC44102TL is a single model with 1/2 inch FIP inlet and dual 1/2 inch and 7/16 inch slip-joint outlets; select it when your supply matches those exact connections.

What does the 1/2 inch FIP inlet mean once the stop is installed?

It connects directly to a 1/2 inch female iron pipe thread coming from the wall or floor, providing the shut-off point for the fixture supply line.

How does the slip-joint outlet standard limit what tubing I can use?

The outlet accepts either 1/2 inch or 7/16 inch outside-diameter tubing with a slip-joint nut and ferrule, so only those two sizes will seal properly.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.