We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Six clear vertical badge holders with black zip seals and three punched holes each

Viator Gear ID Card Holders-6p 6 Pack Badge Holder 2.5" x 3.8

SKU CH-HH9D-45JN8

Six waterproof badge holders with resealable zips and three punched holes each, sized 2.5 by 3.8 inches

  • SizeSmall
  • TypeWallets & Billfolds
  • ColorBlack
  • Color MappingBlack
  • MaterialStainless Steel
  • FeaturesRetractable, Waterproof
  • Six-pack value for team or personal use
  • 4 x 3.8 inch interior fits cards with room to spare
  • Resealable zip keeps moisture and dust out
  • Clear face lets scanners read IDs without removal
  • Three pre-punched holes for lanyard, clip or rope attachment

Six-pack vertical badge holders for daily ID use

This set supplies six clear plastic holders sized 2.5 by 3.8 inches, each with an inner cavity of 2.4 by 3.8 inches. The vertical layout lets nurses, office staff and students slide credentials in and out quickly. A resealable zip closure keeps moisture and dust away from the card surface.

Capacity covers standard cards

Each holder fits a typical credit-card format ID, work badge or student card without forcing. The 2.4-inch internal width adds a small margin so cards do not bind, yet the sleeve stays slim enough for pockets or lanyards. Thicker proximity cards or multiple cards stacked together will exceed the space.

Stainless-steel reinforced frame

The supplier lists stainless steel as the structural material, giving the edges rigidity that resists bending during repeated attachment. Pre-punched holes include a centre slot for lanyards or retractable reels and two side holes for cords or clips, allowing the holder to ride on belts, bags or badge reels without twisting.

Highlights

  • Six-pack value for team or personal use
  • 4 x 3.8 inch interior fits cards with room to spare
  • Resealable zip keeps moisture and dust out
  • Clear face lets scanners read IDs without removal
  • Three pre-punched holes for lanyard, clip or rope attachment

Specifications

BrandViator Gear
ModelID Card Holders-6p
Part NumberID Card Holders-6p
SizeSmall
TypeWallets & Billfolds
ColorBlack
Color MappingBlack
MaterialStainless Steel
FeaturesRetractable, Waterproof
Care InstructionsHand Wash

Questions about this item

Will the 2.5" x 3.8" holders fit alongside the thicker proximity cards I already carry on my lanyard?

The inner dimension is 2.4"W x 3.8"L, giving enough room for standard ID, credit or student cards; thicker proximity cards may fit but the zip closure must still seal fully.

How can I verify the resealable zip is sealing properly after I load my cards?

Close the zip completely, then gently press the holder — no air or water should escape, and the clear front stays transparent so you can visually confirm the card sits flat inside.

What comes in the pack and do I need to buy lanyards or clips separately?

The pack contains six vertical badge holders with three pre-punched holes each; lanyards, key chains, retractable clips or ropes are not included and must be purchased separately.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.