VEVOR PTO Slip Clutch 1 3/8" Round Ends 20-55 HP 900 Nm Black heavy equipment attachment
- Other Appliances
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
VEVOR
A pair of 49-inch spring-steel bale spears rated for 4500 lbs each, powder-coated red for corrosion resistance and supplied with bolt-on sleeves for quick-attach loaders
This pair of 49-inch hay spears is built from 60Si2Mn spring steel and rated at 4500 lbs capacity per spear. The powder-coated red finish resists corrosion in agricultural environments. They attach to quick-attach hookups on tractors, loaders and telehandlers using the supplied bolt and nut system. Farmers and contractors handling large square or round bales will find them suited to daily farm work.
Each spear undergoes special heat treatment so the 1 3/4-inch diameter shaft resists permanent deformation when driven into dense bales at the rated 4500 lbs. The sharp taper point penetrates cleanly without shoving bales off the stack, allowing repeated cycles without loss of straightness. The 60Si2Mn material maintains its yield strength through sustained seasonal use rather than yielding after a few heavy lifts.
The red powder coating protects the steel from rust caused by moisture, silage acids and manure. A 45# steel sleeve at the mount distributes clamping force, reducing metal-on-metal chatter during transport. At 55.4 lbs total shipping weight for the pair, the spears add minimal mass to the loader, keeping hydraulic demand and fuel consumption close to baseline levels.
| Type | Other Appliances |
|---|
The spear has no moving parts, motor or electronics, so it produces no heat and makes no noise regardless of how long it is used.
The machine needs a standard quick-attach hookup or receiver hitch that accepts a 1 3/4" diameter sleeve secured with the supplied hex nut.
The 49" length and 1 3/4" sleeve are designed for current quick-attach plates; older 50" brackets may have different hole spacing or pin diameters that prevent a secure fit.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?