Value Brand
Value Brand Red Brass Reducing Tee 1/2 x 1/2 x 3/8 FNPT
Red brass reducing tee connects 1/2 in. and 3/8 in. FNPT threads, rated to 125 psi from -20 to 400 °F
- TypeOther
- Red brass construction resists corrosion and dezincification
- Reducing tee connects 1/2 in., 1/2 in. and 3/8 in. FNPT branches
- Rated for 125 psi working pressure at 400 °F
- Meets ASTM B584, ASME B16.15 and ANSI B1.20.1 standards
- Class 125 fitting suitable for water, oil and gas lines
Red Brass Reducing Tee 1/2 x 1/2 x 3/8
This red brass reducing tee connects three pipes with female NPT threads in a T configuration. It joins two 1/2 inch lines to a single 3/8 inch branch for fluid distribution. The fitting suits residential and commercial plumbing installations requiring a durable branch connection. It meets ASTM B584 and ASME B 16.15 standards for material and dimensions.
Class 125 FNPT construction
The Class 125 rating supports a maximum pressure of 125 psi across the operating range. Female NPT threads on all three ports allow direct assembly with standard male pipe threads without soldering. Red brass material resists dezincification and handles temperatures from -20 to 400 degrees Fahrenheit. The threaded joints enable disassembly for maintenance or system reconfiguration.
125 psi pressure rating
This single limit determines if the tee matches your system pressure requirements. Installations exceeding 125 psi need a higher-rated fitting to avoid failure. The temperature ceiling of 400 degrees Fahrenheit also bounds use in high-heat applications. California Proposition 65 warnings apply due to chemical content.
Highlights
- Red brass construction resists corrosion and dezincification
- Reducing tee connects 1/2 in., 1/2 in. and 3/8 in. FNPT branches
- Rated for 125 psi working pressure at 400 °F
- Meets ASTM B584, ASME B16.15 and ANSI B1.20.1 standards
- Class 125 fitting suitable for water, oil and gas lines
Specifications
| Brand | Zoro Select |
|---|---|
| Type | Other |
Questions about this item
What pressure does the FNPT Class 125 thread handle?
The FNPT Class 125 connection is rated for a maximum of 125 psi under the ASME B16.15 standard.
What pipe diameters does the 1/2 x 1/2 x 3/8 reducing tee fit?
It connects two 1/2 inch FNPT ports to one 3/8 inch FNPT port, matching the listed pipe size specification.
How do I seal the FNPT threads without cracking the brass?
Apply PTFE tape or pipe dope on the male threads only, then tighten one to two turns past finger-tight to avoid over-stressing the red brass body.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Scosche
Scosche 8" PRO Midbass Driver 200W RMS 400W Peak 60-8000Hz 97dB 4Ω 3.75" Depth
$9.99
0.0001192BTC
In stock