We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Chrome wheel stud installer kit for Nissan 310, M12x1.25 thread

V-Project Inc

V-Project Inc Wheel Stud Installer Kit Nissan 310 1979-1982 M12x1.25 Chrome

SKU CH-94EE-7M850

Wheel stud installer kit for Nissan 310 1979-1982 with M12x1.25 chrome hardware

  • Colorchrome
  • Commercial/ResidentialResidential
  • Installs wheel studs on Nissan 310 1979-1982
  • M12 x 1.25 thread matches factory spec
  • Chrome finish resists corrosion during use
  • 20 mm x 24.9 mm x 43.15 mm tool fits pin studs
  • Works across Nissan, Infiniti, Subaru and more

Nissan 310 Wheel Stud Installer

This kit provides the tools needed to install M12x1.25 pin-type wheel studs on a Nissan 310 produced between 1979 and 1982. The chrome-finished components are sized at 20mm by 24.9mm by 43.15mm for a precise fit. It is intended for residential garage use rather than commercial shop environments.

Replaces Damaged Pin Stud Hardware

The installer addresses stripped or broken factory studs that use the M12x1.25 thread pitch. The jump is worth it when the original hardware can no longer hold a wheel securely and a press-in replacement is required. It covers the specific pin-stud design used on these models.

Handles M12x1.25 Pin Stud Installation

The kit comfortably handles the installation of pin-type studs with the specified thread dimensions across the listed Nissan 310 years. It runs out when the application calls for a different thread size, a non-pin stud design, or a vehicle outside the 1979 to 1982 range.

Highlights

  • Installs wheel studs on Nissan 310 1979-1982
  • M12 x 1.25 thread matches factory spec
  • Chrome finish resists corrosion during use
  • 20 mm x 24.9 mm x 43.15 mm tool fits pin studs
  • Works across Nissan, Infiniti, Subaru and more

Specifications

Brandv-project
Colorchrome
Commercial/ResidentialResidential

Questions about this item

What hub hole size does the M12 x 1.25 installer fit on a 1979-1982 Nissan 310?

The kit is built for M12 x 1.25 pin studs, matching the factory thread on the 310 hubs.

Which step do installers most often miss when pressing the new studs with this tool?

They forget to seat the stud fully before tightening the installer nut, leaving the knurl loose in the hub.

When should the chrome finish on the installer nuts be checked for wear?

Inspect the chrome surfaces after every few uses; replace the nuts if the plating flakes and risks damaging fresh stud threads.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.