Peerless Industrial Group
Peerless Industrial Group Tire Chains Single Bus & RV V-Bar PK2 QG2821
$67.99
0.0008189BTC
In stock
V-Project Inc
V-Project Inc 50mm Extended Wheel Stud M12x1.5 10pcs Gold accessories - wheel
Gold grade 10.9 M12×1.5 studs, 50 mm thread length and 14.22 mm knurl, supplied as a 10-piece set for front and rear fitment on Toyota MR2 1991-1995 and other listed models
- ColorGold
- Commercial/ResidentialResidential
- 50mm extended length fits wide spacers and thick rotors
- M12x1.5 thread matches Toyota hubs from 1991 onward
- 9 grade steel handles high clamping loads safely
- 22mm knurl seats securely in factory hub bores
- Ten gold studs cover front and rear in one set
Extended Wheel Studs M12x1.5 50mm
These 10.9 grade extended wheel studs measure 50mm in thread length with a 14.22mm knurl diameter. The gold finish distinguishes them from standard hardware. They are designed for front and rear hubs on compatible Toyota and Scion models.
Fitment for Toyota and Scion vehicles 1991-2016
This kit suits owners of listed Toyota models including MR2, Camry, Corolla, and Tacoma across the specified years plus Scion tC, xA, and xB. Builders working on other makes or pre-1991 Toyota applications should verify specifications before purchasing.
Critical specification: 14.22mm knurl diameter
The 14.22mm knurl head size determines whether the stud seats correctly in the hub flange. Confirm this measurement matches your original equipment exactly; a mismatch will prevent proper installation regardless of thread pitch or length.
Highlights
- 50mm extended length fits wide spacers and thick rotors
- M12x1.5 thread matches Toyota hubs from 1991 onward
- 9 grade steel handles high clamping loads safely
- 22mm knurl seats securely in factory hub bores
- Ten gold studs cover front and rear in one set
Specifications
| Brand | v-project |
|---|---|
| Color | Gold |
| Commercial/Residential | Residential |
Questions about this item
What knurl diameter must the hub hole accept for these 14.22 mm studs?
The hub hole must accept a 14.22 mm knurl diameter so the 50 mm M12x1.5 studs seat and lock correctly.
Which step is most often missed when pressing in the grade 10.9 studs?
Clean the hub bore, coat the knurl with anti-seize, press each stud squarely until the 14.22 mm knurl fully seats, then verify no protrusion before torquing lug nuts.
When should the gold 10.9 studs be inspected or replaced?
Inspect the 10 studs at every wheel removal; replace any showing thread damage, corrosion on the gold finish, or a loose 14.22 mm knurl in the hub.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
