We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Square black 60 mm case fan 25 mm thick three wire connector

UTEK

UTEK D06K-24TU 45B 60x60x25mm DC24V 0.10A 3-line case fan

SKU CH-FB6Q-5ZAF0

A 60 mm DC 24 V case fan with a locked-rotor sensor, 4150 RPM speed, 21.19 CFM airflow and 31 dBA noise

  • TypeAccessories
  • Quiet operation at 31 dBA noise level
  • Moves 21.19 CFM of air for effective cooling
  • Runs on standard DC 24V power supply
  • Low 1.92W power draw saves energy
  • Locked rotor sensor protects against stall

Compact 60 mm 24 V case fan

The UTEK D06K-24TU 45B is a 60 × 60 × 25 mm DC fan rated for 24 V operation with a maximum current draw of 0.10 A. It spins at 4150 RPM to deliver 21.19 CFM of airflow while producing 31 dBA of noise. A three-wire connection provides a locked-rotor sensor signal for monitoring.

Suited for tight 24 V cooling spots

This fan fits builders who need a low-profile 60 mm frame powered from a 24 V rail in industrial enclosures, embedded boards or small-form-factor chassis. The sleeve bearing and modest airflow make it a match for light heat loads where space is at a premium. Buyers who need higher static pressure, PWM speed control or a larger frame should look elsewhere.

21.19 CFM at 4150 RPM with 31 dBA

At full speed the fan moves 21.19 CFM, which is adequate for spot-cooling voltage regulators, compact power supplies or single-board computers in a 60 mm cut-out. The 1.92 W input power leaves little headroom for dense fin stacks or restrictive filters; airflow will drop sharply when the fan faces significant back-pressure. The locked-rotor sensor alerts the host if the rotor stalls, but there is no PWM input for dynamic speed scaling.

Highlights

  • Quiet operation at 31 dBA noise level
  • Moves 21.19 CFM of air for effective cooling
  • Runs on standard DC 24V power supply
  • Low 1.92W power draw saves energy
  • Locked rotor sensor protects against stall

Specifications

TypeAccessories

Questions about this item

Does my system need a 24 V DC header to run this fan?

Yes, the fan requires a DC 24 V supply and draws 0.08 A typical with a 0.10 A maximum.

Can I plug the 3-pin connector into an older 3-pin motherboard header?

The 3-pin connector fits standard 3-pin headers, but the header must supply 24 V DC or the fan will not spin.

How can I confirm the fan is running at its rated speed after installation?

Monitor the tachometer signal on the third wire; it should report 4150 RPM when the fan receives full 24 V power.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.