We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
A rectangular brass block with two large screw terminals and a clear plastic cover

Unique-Bargains

Unique-Bargains 2 Way Power Distribution Block 0 Gauge In/Out Car Audio Splitter

SKU CH-625B-SE8PK

A 2-way power distribution block that splits one 0-gauge input into two 0-gauge outputs for clean car audio amplifier wiring

  • TypeGadgets
  • Connects two amplifiers to one power source with 0GA input and dual 0GA outputs
  • Screw-down clamps secure 13mm cables for reliable current flow
  • Brass construction with corrosion-resistant plating ensures long-term conductivity
  • Clear plastic cover protects connections from impact and debris
  • Compact 62 x 50 x 33mm block simplifies wiring for a clean install

2-way 0-gauge power distribution block

This 2-way power distribution block connects up to two amplifiers to a single 0-gauge power source. It accepts one 0-gauge input and provides two 0-gauge outputs, each with a 13 mm wire entry. The block helps reduce wiring clutter for a cleaner, more professional car audio installation.

Screw-down clamps, brass construction.

Screw-down wire clamps secure each conductor firmly without soldering. The body is made from solid brass with corrosion-resistant plating for reliable conductivity. An impact-resistant screw-on clear plastic cover shields the connections from debris and accidental shorts.

Requires in-line fuses, single grounding point use

You must install in-line fuses between the distribution block and each amplifier for circuit protection. The unit can also combine multiple amplifier ground wires to a single grounding point. Mounting holes are 4 mm in diameter and spaced 40 mm apart, requiring a 5 mm hex wrench for the terminal screws.

Highlights

  • Connects two amplifiers to one power source with 0GA input and dual 0GA outputs
  • Screw-down clamps secure 13mm cables for reliable current flow
  • Brass construction with corrosion-resistant plating ensures long-term conductivity
  • Clear plastic cover protects connections from impact and debris
  • Compact 62 x 50 x 33mm block simplifies wiring for a clean install

Specifications

BrandUnique Bargains
TypeGadgets

Questions about this item

How often should the screw-down clamps on the 0 GA inputs and outputs be re-tightened?

Check the 5 mm hex clamps after the first few heat cycles and then at each major service; brass plating resists corrosion so they rarely loosen once seated.

At what current does the solid brass block become the bottleneck in a sustained run?

The block is rated for 0 GA wire (13 mm bore), so the practical limit is the ampacity of that cable and the in-line fuses you install, not the distributor itself.

Does the clear plastic cover trap heat when the system runs all day?

The impact-resistant cover adds only 33 mm of height and is ventilated by the open wire ports, so heat dissipates through the brass body rather than building up inside.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.