We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
White rectangular plastic enclosure with two cable glands and a ground bolt, pole-mount tabs visible

Tycon Power

Tycon Power ENC-ESP-100-POE enclosure for surge protectors

SKU CH-XGWP-V4JH4

Weatherproof enclosure mounts TPESP-100-POE surge suppressors on towers or masts with dual CAT5/6 feed-throughs, grounding bolt and UV-resistant housing rated IP65

  • Weatherproof IP65 and NEMA 4X rating shields surge suppressors from harsh outdoor conditions
  • UV-resistant plastic construction withstands -50 to +85 °C for long-term reliability
  • Two CAT5/6 feed-throughs clamp cables for strain relief and sealed entry
  • External ground bolt enables proper grounding to protect connected equipment
  • Pole or wall mounting options allow flexible placement near antennas or towers

Purpose-built housing

The ENC-ESP-100-POE enclosure is manufactured by Tycon Power Systems to house TPESP-100-POE series Ethernet surge suppressors. It places the suppressor at the tower or mast near the protected equipment for short cable runs. Two CAT5/6 feed-throughs clamp each cable for strain relief and sealing. An external ground bolt simplifies proper earthing.

Fit for outdoor installs, not for indoor racks

Installers mounting suppressors on poles or walls in exposed locations will value the UV-resistant plastic shell and IP65 rating. The 4 mm ground bolt and wide temperature range support permanent outdoor deployment. Teams needing a rack-mount chassis, a larger multi-port housing, or an indoor-only enclosure should look at different form factors.

Holds one suppressor with cable headroom

The 203 x 45 x 45 mm body accepts a single TPESP-100-POE unit and two clamped CAT5/6 cables with room for routing. Operating limits span -50 to +85 °C, so the enclosure survives extreme cold and heat. It does not accommodate multiple suppressors, fibre terminations or power distribution gear.

Highlights

  • Weatherproof IP65 and NEMA 4X rating shields surge suppressors from harsh outdoor conditions
  • UV-resistant plastic construction withstands -50 to +85 °C for long-term reliability
  • Two CAT5/6 feed-throughs clamp cables for strain relief and sealed entry
  • External ground bolt enables proper grounding to protect connected equipment
  • Pole or wall mounting options allow flexible placement near antennas or towers

Specifications

BrandTycon Power Systems
ModelENC-ESP-100-POE

Questions about this item

Which surge suppressor series fits inside this ENC-ESP-100-POE enclosure?

It is designed specifically for the TPESP-100-POE series of Ethernet surge suppressors.

Can I mount this IP65-rated enclosure on an existing antenna mast without new hardware?

Yes, the enclosure supports pole or wall mounting and accepts standard mast clamps for tower or antenna installations.

How do I confirm the CAT5/6 feedthroughs are sealed correctly after installation?

Each feedthrough clamps down on the cable to provide strain relief and sealing; verify the cable is held firmly and no gap remains around the entry point.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.