Tripp Lite P005-006-ABL 6 ft 14 AWG power extension cord

6 ft C13 to C14 extension cord

The Tripp Lite P005-006-ABL is a 6 ft power extension cord built with 14 AWG conductors and IEC-320-C14 to IEC-320-C13 connectors. It suits technicians and office users who need to bridge the gap between a C14 inlet on a PDU or UPS and a C13 plug on a computer, monitor or power supply. The blue SJT jacket and fully molded blue ends make the cable easy to spot in a crowded rack or under a desk. It is sold new and carries a UL listing for safety compliance.

15 A 250 V rating with 14 AWG headroom

The cord handles up to 15 A at 250 V, giving comfortable headroom for typical desktop workstations, printers, scanners and single-supply servers that draw well below the limit. The 14 AWG wire gauge supports this rating without excessive voltage drop over the 6 ft length. It runs out of capacity when the connected load approaches the 15 A maximum, so high-current devices such as multi-GPU workstations or large laser printers on the same circuit would need a heavier gauge or a dedicated feed.

Operating range -20 to 60 °C with passive cooling

The assembly is rated for an operating temperature range of -20 to 60 °C and a humidity range of 10 to 85 % RH, with identical storage limits. Because it has no active components, it produces no noise and adds negligible power draw beyond the minimal resistive loss of the 14 AWG conductors. The flexible SJT jacket stays pliable across the temperature span, allowing easy routing in tight cable trays or behind equipment racks without stiffening or cracking.