We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Beige shielded crossover cable with RJ48C connectors, 10 ft

Tripp Lite

Tripp Lite N266-010 10ft RJ48C Shielded Crossover Cable Beige

SKU CH-P0W1-2PSV3

Shielded RJ48C crossover cable with 22AWG pairs for T1 circuits, 10ft length

  • Shielded construction protects T1 circuits from interference
  • Premium Quabbin 9720 cable certified for T1 performance
  • Two balanced 22AWG pairs meet ANSI T1.403 100ohm impedance spec
  • 10ft length connects T1 equipment with RJ48C male ends
  • Crossover wiring enables direct device-to-device T1 links

T1 Crossover Cable for Shielded Circuits

This ten-foot shielded crossover cable uses RJ48C connectors on both ends for T1 line connections. It is built with Quabbin 9720 cable certified to the T1 standard. The construction suits installers and technicians who need a reliable link for dedicated T1 circuits and equipment.

Fits Standard T1 Patch Panels and Interfaces

The cable terminates in male RJ48C plugs that match typical T1 patch panels, CSU/DSU ports and network interface cards. Its shielded, 22 AWG solid-conductor pairs maintain the 100 ohm impedance required by the ANSI T1.403 loss budget. No unshielded Cat5 substitute is needed when this cable is used.

Maintains Signal Integrity Over Extended Runs

The individually shielded pairs and 100 ohm balanced design keep attenuation within the 5.5 dB allowance specified by ANSI T1.403. This performance holds across the full ten-foot length during continuous T1 traffic. Generic unshielded patch cables cannot guarantee the same loss budget compliance.

Highlights

  • Shielded construction protects T1 circuits from interference
  • Premium Quabbin 9720 cable certified for T1 performance
  • Two balanced 22AWG pairs meet ANSI T1.403 100ohm impedance spec
  • 10ft length connects T1 equipment with RJ48C male ends
  • Crossover wiring enables direct device-to-device T1 links

Specifications

BrandTRIPP LITE
ModelN266-010

Questions about this item

Does the 100 ohm impedance and 5.5 dB loss budget hold up on a 10 ft run?

The cable is built to ANSI T1.403 with two 22 AWG balanced pairs at 100 ohm impedance and a 5.5 dB loss budget, so the 10 ft length stays within spec.

Will the shielded 22 AWG pairs and Quabbin 9720 construction run cool and quiet in a rack all day?

Passive copper generates no noise or heat; the shielded 22 AWG pairs simply carry the T1 signal without active components.

What T1 equipment with RJ-48C ports do I need at each end to use this crossover cable?

It requires two devices with RJ-48C interfaces wired for T1 cross-over — typically a CSU/DSU, router WAN port or multiplexer.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.