We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
White steel wall bracket for wireless access point, 10 lb load

Tripp Lite

Tripp Lite ENBRKT WAP Wall Bracket White 10 lb

SKU CH-31M2-GJEST

Durable steel wall bracket securely mounts wireless access points up to 10 lb

  • Mounts WAP high for better coverage and tamper resistance
  • Heavy-duty cold-rolled steel with white powder-coated finish supports 10 lb
  • Fits most access-point bolt patterns including Cisco and Aruba
  • Open rear cutout enables clean cable routing and less clutter
  • Ready for horizontal or vertical wall and ceiling mounting

Wall-Mount Bracket for Wireless Access Points

The Tripp Lite ENBRKT is a steel mounting bracket designed to secure a Wi-Fi access point high on a wall or ceiling. It protects the device from tampering while positioning it for optimal signal coverage in indoor environments. The bracket suits offices, classrooms, hotels and small businesses needing organised, out-of-the-way installation. Its white powder-coated finish blends with typical ceiling and wall surfaces.

Thermals Noise and Power Draw

As a passive steel bracket, the ENBRKT generates no heat, produces no noise and draws no electrical power. It imposes no thermal load on the mounted access point and does not restrict airflow around the device. The open rear cutout allows cables to route cleanly without adding clutter that could impede ventilation. Operation is completely silent and has zero impact on energy consumption.

Upgrade Path and When It Is Worth It

This bracket replaces makeshift shelf placements, adhesive mounts or low-positioned hardware that leave access points vulnerable to damage or signal obstruction. The jump is worth it when a WAP must be secured against tampering in shared spaces or lifted above obstructions for better coverage. It is not suited for outdoor installations, devices exceeding the rated load or mounting surfaces that cannot accept user-supplied fasteners.

Highlights

  • Mounts WAP high for better coverage and tamper resistance
  • Heavy-duty cold-rolled steel with white powder-coated finish supports 10 lb
  • Fits most access-point bolt patterns including Cisco and Aruba
  • Open rear cutout enables clean cable routing and less clutter
  • Ready for horizontal or vertical wall and ceiling mounting

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the Tripp Lite ENBRKT wall bracket, and what step is often missed?

Mount the bracket horizontally or vertically on a wall or ceiling using your own screws and anchors; the step people skip is pre-drilling pilot holes for the user-provided hardware.

What maintenance or replacement will the ENBRKT need later?

The cold-rolled steel bracket with white powder-coat finish requires no scheduled maintenance; only replace it if physical damage or corrosion appears.

What limit appears first under sustained use of the ENBRKT?

The 10 lb load rating is the first limit; exceeding it risks bracket deformation or mounting failure.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.