Trakbelt360
Trakbelt360 100Pcs RJ45 Connectors Cat6 Cat5e Cat5 UTP 8P8C 50 Micron Gold Plating
A pack of one hundred clear RJ45 modular plugs compatible with Cat6, Cat5e and Cat5 cables, featuring 50 micron gold-plated contacts for reliable data transmission
- 100 connectors in one pack simplify large wiring jobs
- 50 micron gold-plated contacts improve signal integrity
- Clear UTP 8P8C housing fits Cat6, Cat5e and Cat5 cable
- Compatible with standard RJ45 crimp tools for quick assembly
- Single-use design locks wires permanently after crimping
100-Pack RJ45 Modular Plugs
This pack contains one hundred clear plastic RJ45 modular plugs designed for terminating unshielded twisted-pair cables. The connectors accept Cat6, Cat5e and Cat5 conductors with an 8P8C pin layout. Fifty-micron gold plating on the contacts reduces resistance and helps maintain signal integrity. Each plug is intended for a single crimp and cannot be reused once fixed.
DIY Installers and Small Project Builders
Suits technicians, hobbyists and homeowners who create custom patch leads during renovation or when adding network points. The universal fit works with standard crimp tools and solid-conductor UTP cable. Not suitable for shielded or FTP cables, stranded conductors, or installations that require tool-less or reusable terminations. Buyers needing angled boots, colour-coded strain relief or bulk jars of five hundred pieces should look elsewhere.
50-Micron Gold Contact Plating
The fifty-micron gold layer on the eight contact pins is the specification that determines long-term reliability. Thicker plating resists oxidation and wear better than thinner flash coatings, preserving low contact resistance over repeated mating cycles. Verify that your cable jacket diameter and conductor gauge match the plug’s internal dimensions before crimping.
Highlights
- 100 connectors in one pack simplify large wiring jobs
- 50 micron gold-plated contacts improve signal integrity
- Clear UTP 8P8C housing fits Cat6, Cat5e and Cat5 cable
- Compatible with standard RJ45 crimp tools for quick assembly
- Single-use design locks wires permanently after crimping
Specifications
No published specifications for this item yet.
Questions about this item
What cable diameters do the 100 clear UTP 8P8C plugs accept?
The plugs are designed for standard Cat5, Cat5e and Cat6 solid UTP conductors; the clear housing lets you verify wire order before crimping.
Which crimp tool works with these RJ45 ends, and what step do installers often miss?
Any general RJ45 crimp tool fits the 8P8C body; the step often missed is fully seating each conductor to the plug tip before squeezing, because the gold-plated contacts cannot be re-used once crimped.
When should the 50-micron gold contacts be replaced in a permanent installation?
The connectors are one-off assembly; if a link fails certification or shows intermittent errors, cut off the plug and terminate a fresh connector from the remaining pack.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



