We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Green circuit board with multiple relay modules and terminal blocks

Traditions (Generic)

Traditions (Generic) 250V 2A 5V Relay Module computer power cord

SKU CH-AGEM-HHPAF

Solid-state relay module switches 250 V 2 A loads from a 5 V signal

  • Solid-state switching for silent, bounce-free operation
  • 250 V 2 A rating handles mains-level loads safely
  • 5 V logic input works directly with microcontroller GPIO pins
  • Multi-channel options from 1 to 8 relays suit varied project scales

250V 2A Relay Module for Switching

This 5V relay module provides 1, 2, 4 or 8 solid-state channels rated at 250V 2A each. It suits hobbyists and engineers who need low-voltage control of mains-rated loads in custom automation or test rigs. The high or low-level trigger option fits common microcontroller logic without extra circuitry.

Simple Header Connections, Watch Load Limits

Installation uses standard pin headers for power, ground and signal lines; no soldering is required for typical breadboard or protoboard use. The solid-state design avoids mechanical wear but generates heat under sustained 2A loads, so verify adequate airflow. Ensure the control voltage matches the 5V specification to prevent channel damage.

Highlights

  • Solid-state switching for silent, bounce-free operation
  • 250 V 2 A rating handles mains-level loads safely
  • 5 V logic input works directly with microcontroller GPIO pins
  • Multi-channel options from 1 to 8 relays suit varied project scales

Specifications

No published specifications for this item yet.

Questions about this item

How do I verify the relay module switches correctly after wiring it?

Apply 5 V to the control input and measure 250 V 2 A on the load side; the solid-state output should conduct only while the control signal is present.

What comes in the box and what must I source separately?

The module itself is supplied; you must provide a 5 V control supply, load wiring rated for 250 V 2 A, and any mounting hardware.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

More in Computer Power Cords

Similar items

Same shelf, same checkout — eight coins and a 30-minute rate lock.