We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Titanium Micro Nitro Pro M.2 NVMe 2280 cooler with four copper heat pipes and 30mm PWM fan

Titanium Micro

Titanium Micro Nitro Pro M.2 NVMe 2280 Dual Cooler SSD Cooling

SKU CH-EVTN-3B7SJ

A heatsink with four copper heat pipes and a 30 mm PWM fan lowers M.2 2280 NVMe drive temperatures by roughly 30 to 40 °C and includes thermal tape.

  • Lowers SSD temps by 30 to 40 °C
  • Extra 10 to 20 °C drop versus fanless heatsinks
  • Four pure-copper heatpipes move heat fast
  • 30 mm PWM fan auto-adjusts for quiet cooling
  • Fits single- or double-sided 2280 NVMe drives

Active Cooling for M.2 NVMe 2280 SSDs

The Titanium Micro Nitro Pro is an active cooler built for single-sided or double-sided M.2 NVMe 2280 solid-state drives. It combines four pure copper heat pipes with a 30 mm PWM fan to move heat away from the drive during sustained workloads. The kit includes thermal tape, screws and a screwdriver for straightforward desktop installation.

Suited for Enclosed Builds.

This cooler suits desktop builders who can accommodate a 30 mm fan and need lower drive temperatures under heavy write loads. It is not intended for fanless systems that rely on passive dissipation, nor for laptops or small-form-factor chassis where a 30 mm fan cannot be mounted or powered.

Temperature Drop of 30 to 40 °C Over Bare Drive

The manufacturer states the Nitro Pro can reduce SSD temperatures by approximately 30 to 40 °C depending on the environment, and by an additional 10 to 20 °C compared with passive heatsinks. This figure is the primary indicator of whether the cooler meets a specific thermal target.

Highlights

  • Lowers SSD temps by 30 to 40 °C
  • Extra 10 to 20 °C drop versus fanless heatsinks
  • Four pure-copper heatpipes move heat fast
  • 30 mm PWM fan auto-adjusts for quiet cooling
  • Fits single- or double-sided 2280 NVMe drives

Specifications

No published specifications for this item yet.

Questions about this item

Do I need a free motherboard M.2 slot and an NVMe 2280 drive to use this cooler?

Yes, it mounts directly onto a single- or double-sided NVMe 2280 SSD in a standard desktop M.2 slot and includes thermal tape, screws and a screwdriver for installation.

Will the 30 mm PWM fan and four copper heat pipes clear tall memory modules or a large GPU back-plate?

The low-profile heatsink sits close to the drive; most standard DIMMs and graphics cards leave enough clearance, but verify your board layout before fitting.

How can I confirm the cooler is working after I fit it?

Monitor the SSD temperature in BIOS or software — expect a drop of roughly 30 to 40 °C under load, and the fan should spin up automatically as the drive warms.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.