We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Square grey thermal pad sheet 100x100mm soft silicone texture

Thermal Grizzly

Thermal Grizzly Minus Pad Extreme 100x100 thermal pad

SKU CH-G921-TS954

Ultra high-performance silicone thermal pad with 15 W/mK conductivity adapts like putty for optimal heat transfer

  • Ultra-soft consistency fills microscopic gaps for maximum contact
  • High thermal conductivity keeps CPU and GPU temperatures low under load
  • Non-bleeding formula prevents mess and protects surrounding components
  • Long-term stability maintains performance without frequent reapplication
  • 100 x 100 mm size with 15 mm thickness suits large dies and VRM arrays

Ultra-High-Performance Thermal Pad

The Thermal Grizzly Minus Pad Extreme is an ultra high-performance thermal pad designed for CPUs and GPUs in high-performance computing builds. Its consistency resembles a kneaded mass that flows into microscopic gaps under minimal pressure. The self-adhesive silicone layer holds position during installation and maintains contact through thermal cycling. Enthusiasts and system integrators who need reliable gap-filling without liquid paste mess will appreciate the clean handling.

100 x 100 mm Sheet with 1.5 mm Thickness

The 100 by 100 millimetre sheet can be cut to fit VRM arrays, memory modules or large GPU dies, while the 1.5 millimetre thickness bridges taller component stacks. High compressibility lets the material conform to uneven surfaces and fill micro-voids that thinner pads cannot reach. Thermal conductivity remains consistent across the full area, so heat spreads evenly to the heatsink. Extremely thin gaps below a fraction of a millimetre may still favour liquid metal or grease for absolute minimum resistance.

Thermals, Noise and Power Draw

Because the pad is passive, it adds zero fan noise and draws no power while moving heat away from the die. The silicone compound resists drying, pumping out or bleeding over years of heating and cooling cycles. Stable thermal impedance keeps temperatures predictable, allowing fan curves to stay lower during sustained loads. No electrical conductivity means accidental contact with PCB traces poses no short-circuit risk.

Highlights

  • Ultra-soft consistency fills microscopic gaps for maximum contact
  • High thermal conductivity keeps CPU and GPU temperatures low under load
  • Non-bleeding formula prevents mess and protects surrounding components
  • Long-term stability maintains performance without frequent reapplication
  • 100 x 100 mm size with 15 mm thickness suits large dies and VRM arrays

Specifications

No published specifications for this item yet.

Questions about this item

How does the 100 x 100 mm Minus Pad Extreme fit on an older GPU with several small memory chips and a large die?

The 100 x 100 mm sheet can be cut to size, letting you cover each chip and the main die on an older graphics card without gaps.

After installing the pad, how can I check it is making proper contact across the whole surface?

Tighten the cooler until the pad compresses evenly, then run a load test; steady temperatures show the silicone has filled every micro-gap.

Does the package include any tools or cleaning wipes, or do I need to buy them separately?

Only the self-adhesive thermal pad is supplied; isopropyl wipes and a plastic scraper for old paste removal must be purchased separately.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.