We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Y-shape 2-pin IP68 waterproof power adapter with 16AWG wires, 27cm total length

TAURKENAM

TAURKENAM Y-Shape 2-Pin IP68 Waterproof Power Adapter 16AWG 27cm

SKU CH-9NBH-DE4E1

IP68-rated Y-splitter joins one male to two female 2-pin connectors on 16AWG cable, 27 cm total with 13.5 cm branches, for waterproof LED lighting on vehicles and boats

  • IP68 waterproof rating protects connections in wet environments
  • Y-shape splitter powers two LED strips from one source
  • 16 AWG pure copper conductors ensure reliable current flow
  • 27 cm total length with 13.5 cm branches fits tight spaces
  • Metal locking nuts prevent accidental disconnection during vibration

Y-Shape 2-Pin Waterproof Power Adapter

The TAURKENAM adapter is a new IP68-rated Y-splitter built with 16AWG pure-copper pigtails and metal-threaded nuts. It provides one male input that divides into two female outputs, plus two extra male and one extra female 10 cm leads for flexible wiring.

Installers needing a single-to-dual waterproof

The kit suits anyone extending or branching 2-pin LED lighting on motorcycles, cars, trucks, boats or indoor and outdoor strips. Builders who require more than two branches, a different pin count, or a non-waterproof connection should look at other solutions.

IP68 rating with 16AWG conductors

The connectors meet the IP68 ingress-protection standard and use 16AWG wire across a 27 cm total length with 13.5 cm per branch, making the waterproof seal and conductor gauge the key spec for deciding fit.

Highlights

  • IP68 waterproof rating protects connections in wet environments
  • Y-shape splitter powers two LED strips from one source
  • 16 AWG pure copper conductors ensure reliable current flow
  • 27 cm total length with 13.5 cm branches fits tight spaces
  • Metal locking nuts prevent accidental disconnection during vibration

Specifications

No published specifications for this item yet.

Questions about this item

What wire gauge and total cable length do I need to plan for when routing the Y-splitter?

The adapter uses 16AWG pure copper pigtails and measures 27cm end-to-end, with each branch extending 13.5cm from the split point.

How do I achieve the IP68 seal when connecting the male and female threads?

Hand-tighten the metal coupling nuts until the O-rings compress fully; the most common mistake is leaving a visible gap because the nut was only finger-tight.

When should I inspect or replace the supplied 10cm pigtail leads?

Check the 10cm leads at each seasonal change for cracked insulation, corroded pins or loose crimps; replace any lead that shows green oxidation or brittle wire.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.