We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black 8-foot power cord with two-prong plug and tool connector

TAURKENAM

TAURKENAM Power Adapter 8ft 18 AWG 10A 125V AC

SKU CH-R9TJ-E2VB0

Replacement AC power cord for Makita grinders, 8 ft, 18 AWG, 10 A, 125 V AC

  • 8 ft length gives flexible placement for workshop tools
  • 18 AWG 2-wire construction handles 10 A at 125 V AC safely
  • Designed for double-insulated Makita grinders including 9553NB 9554NB 9557NB 9558NB 9560CV 9561CV GA4030K
  • 100 % compatible replacement restores original power performance
  • Brand-new cord backed by 200-day manufacturer warranty

Compatible Replacement Cord

This eight-foot replacement AC power cord is designed for double-insulated Makita angle grinders. It matches the original cable specification with an 18 AWG two-wire construction rated for 10 amps at 125 volts AC. The cord restores power to tools with damaged or worn mains leads.

Upgrade From Damaged Leads

The cord replaces frayed, cut or cracked factory cables that cause intermittent operation or safety hazards. Swapping the lead is worthwhile when the grinder motor and switch remain functional but the power cord insulation has degraded. It returns the tool to service without replacing the entire unit.

Build Integration Needs

The two-wire design suits double-insulated grinders that do not require a grounding conductor. Users must verify their specific model uses a two-pin inlet before fitting this cord. The eight-foot length provides reach for bench or site work while the 18 AWG gauge handles the rated current without excess bulk.

Highlights

  • 8 ft length gives flexible placement for workshop tools
  • 18 AWG 2-wire construction handles 10 A at 125 V AC safely
  • Designed for double-insulated Makita grinders including 9553NB 9554NB 9557NB 9558NB 9560CV 9561CV GA4030K
  • 100 % compatible replacement restores original power performance
  • Brand-new cord backed by 200-day manufacturer warranty

Specifications

No published specifications for this item yet.

Questions about this item

What plug type does this 8 ft 18 AWG cord use for a Makita GA4030K grinder?

It uses a standard two-prong non-polarised plug rated 10 A 125 V AC, matching the original double-insulated tool cord.

Which step do installers most often miss when fitting this replacement cord to a 9557PB angle grinder?

They forget to route the strain-relief grommet into the housing slot before tightening the cord clamp, so the cable can pull loose under vibration.

How often should the 18 AWG 2-wire cable on a 9561CV grinder be inspected for wear?

Check the jacket and strain relief before each heavy-use session; replace the cord if insulation cracks or the grommet splits.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.