We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Brown 8 ft lamp cords with inline switches and stripped wire ends, two-pack

TAURKENAM

TAURKENAM lamp cord with switch 8 ft brown 2-pack power adapter

SKU CH-3P91-5S2NK

Two 8 ft brown lamp cords with inline switches and stripped ends for wiring table or floor lamps

  • 8 ft cord places lamps far from outlets
  • Inline on/off switch 30 from plug for easy access
  • Pre-stripped 1.5 split and tinned .25 ends speed wiring
  • UL listed SPT-1 with polarized plug meets safety standards
  • PVC jacket resists moisture abrasion and sun exposure

Brown Lamp Cord with Switch

This two-pack supplies eight-foot brown lamp cords fitted with an inline on/off switch. Each cord is UL listed with a polarized plug and SPT-1 wiring for household lighting repairs. The vinyl jacket resists moisture, abrasion and prolonged sun exposure. They are intended for rewiring table lamps, floor lamps and similar fixtures.

Inline Switch and Ready Wires

The switch sits 30 inches from the plug end for easy reach from a seated position. Wires are split 1.5 inches and stripped 5/8 inch with tinned 0.25 ends for direct connection to lamp sockets. No additional connectors or tools are required beyond basic wire nuts or terminal screws. The polarized plug ensures correct hot-neutral orientation in any standard outlet.

Two Cords for Single Fixtures

Two cords handle two separate lamps or a matching pair on one circuit. Each cord carries one load up to the SPT-1 rating; they cannot be joined for longer runs or higher current. The eight-foot length suits typical room layouts but falls short for distant outlets or ceiling-mounted fixtures. Builders needing grounded three-wire cords or higher ampacity must choose a different product.

Highlights

  • 8 ft cord places lamps far from outlets
  • Inline on/off switch 30 from plug for easy access
  • Pre-stripped 1.5 split and tinned .25 ends speed wiring
  • UL listed SPT-1 with polarized plug meets safety standards
  • PVC jacket resists moisture abrasion and sun exposure

Specifications

No published specifications for this item yet.

Questions about this item

How long does the tinned wire end last before it oxidises and affects the connection?

The cord ends are tinned 0.25 inches from the factory, providing a protected copper surface that resists oxidation during normal indoor use.

Does the in-line switch get warm or make noise after the lamp runs all evening?

The switch is a simple mechanical on/off device with no electronics, so it runs silently and stays at room temperature during continuous operation.

What tools or parts do I need before I can wire this cord to my lamp socket?

You only need a screwdriver to attach the stripped 5/8-inch wire ends to the lamp socket terminals; no special connectors or crimping tools are required.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.