We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

TAURKENAM

TAURKENAM Gravity Car Phone Holder Mount Vent Clip Auto Lock 2023 Upgrade

SKU CH-WS94-Y7945

Gravity car vent mount auto-locks phones 12 to 15 Pro Max via three-point hook clamp 0.41-0.98 in wide

  • TypeCharger Kit
  • Slide in phone and gravity locks it automatically
  • Three-point hook grips horizontal vents from .41 to .98 in
  • Auto-lock side arms tighten on bumps without buttons
  • Fits iPhone 12 13 14 15 Pro Max and similar phones
  • One-hand pick-up lets you leave the car in seconds

Phone holder for horizontal vents

The TAURKENAM gravity mount clips onto horizontal air vents with a three-point hook that spans 0.41 to 0.98 inches. Sliding a phone into the cradle triggers the auto-lock arms to grip the sides automatically. The design fits iPhone 15 Pro Max, 14, 13 and 12 models along with other phones of similar width. No buttons or manual levers are required to secure the device.

Upgrade from spring or magnetic clips

This 2023 revision replaces holders that rely on spring tension or magnetic pads which can loosen over time or fail on rough roads. The gravity-activated locking mechanism engages instantly when the phone is inserted and releases just as fast when lifted. Drivers who want to keep eyes on the road while mounting or removing their phone will notice the difference immediately.

Check vent orientation and clamp range

Verify that your dashboard vents run horizontally, as the hook cannot grip vertical or circular louvers. Measure the vent blade thickness to confirm it falls between 0.41 and 0.98 inches. Ensure the phone width matches the auto-lock arm travel so the arms can fully engage without obstruction.

Highlights

  • Slide in phone and gravity locks it automatically
  • Three-point hook grips horizontal vents from .41 to .98 in
  • Auto-lock side arms tighten on bumps without buttons
  • Fits iPhone 12 13 14 15 Pro Max and similar phones
  • One-hand pick-up lets you leave the car in seconds

Specifications

TypeCharger Kit

Questions about this item

What vent slat thickness does the hook clamp accept?

The hook clamp fits horizontal vent slats between .41 and .98 inches thick.

How do you secure the phone once it is placed in the holder?

Slide the phone down; gravity pulls the side arms inward and they auto-lock around the device.

When should the vent hook be checked or replaced?

Inspect the three grasp points if the mount shifts on bumps; replace the clip if the hook no longer grips the slats firmly.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.