We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black and yellow rubber cable protector with two channels and flip-open lid, 39 inches long

TAURKENAM

TAURKENAM CP9972 cable protector 2-channel 39in 5000lb black yellow

SKU CH-QCWR-JRZW7

Two-channel cable protector holds wires in 1.18 in by 1 in channels, supports 5000 lb per axle, and meets MUTCD, OSHA, RoHS and REACH standards

  • Protects cables up to 5000 lbs per axle
  • Two channels each 1.18 in wide by 1 in high
  • Operates from -40 °F to 1310 °F
  • Meets MUTCD, OSHA, RoHS and REACH standards
  • Flip-open lid with black-yellow finish for high visibility

Two-channel cable protector for temporary routing

The TAURKENAM CP9972 provides two channels measuring 1.18 inches wide by 1 inch high to route cables across walkways or roadways. Black and yellow colouring and a flip-open lid make the ramp visible to drivers and pedestrians in low light. It suits indoor or outdoor sites where light traffic crosses temporary power or data runs.

Replaces loose covers

Loose mats or duct tape can shift under wheels and create trip hazards; this ramp stays in place and supports up to 5000 lbs per axle. The jump is worth it when vehicles up to that weight cross the cable path regularly and a compliant, reusable solution is required. It is not suited for heavy industrial traffic exceeding the rated axle load.

Flip-open lid eases cable placement on rubber base

The polyurethane lid hinges open so cables can be laid in the channels without threading, then snaps shut to protect them. Rubber base grips most hard surfaces but may slide on wet grass or polished stone. Ensure the operating temperature range of -40 °F to 1310 °F covers the site conditions before deployment.

Highlights

  • Protects cables up to 5000 lbs per axle
  • Two channels each 1.18 in wide by 1 in high
  • Operates from -40 °F to 1310 °F
  • Meets MUTCD, OSHA, RoHS and REACH standards
  • Flip-open lid with black-yellow finish for high visibility

Specifications

No published specifications for this item yet.

Questions about this item

What overall length and width does the CP9972 need on the floor?

The protector measures 39 inches long by 10 inches wide and sits 2 inches high, so allow that footprint plus clearance for the flip‑open lid.

How do you load cables into the two channels and what step is often missed?

Open the polyurethane lid, lay cables in each 1.18‑inch‑wide by 1‑inch‑high channel, then close the lid fully until it latches; the missed step is leaving the lid unlatched, which can let cables slip out.

When should the rubber base or polyurethane lid be replaced?

Replace the unit if the rubber base shows cracking, permanent deformation, or the lid hinge no longer locks securely, as these affect the 5000‑lb per‑axle rating.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.