We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black 6-foot SJT power cord with NEMA 5-15P plug and stripped bare wires, 0.46 inch diameter

TAURKENAM

TAURKENAM 6ft 12AWG NEMA 5-15P to bare end power adapter

SKU CH-4PAK-DQ9RA

A 6-foot SJT cable with a NEMA 5-15P plug and bare-wire end, 12 AWG copper rated for 20 amps, 300 V, 105 °C, UL approved

  • Six-foot length reaches appliances without strain
  • 12 AWG copper conductors handle 20 amp loads safely
  • NEMA 5-15P plug fits standard 110/115/120 V outlets
  • UL-approved SJT jacket rated 300 V, 105 °C, VW-1
  • Pre-stripped bare end speeds DIY wiring and repairs

6 ft NEMA 5-15P to bare-end power cord

This 6 ft cord has a NEMA 5-15P plug on one end and stripped bare wires on the other. It uses 12 AWG SJT cable rated 300 V, 105 °C, VW-1 with fine-stranded copper conductors. The cord diameter is .46 in and carries UL approval. It is built for hard-wiring appliances or DIY projects where a moulded connector is not wanted.

Replaces worn or missing appliance cords

Use it to replace a damaged power cord on tools, grinders, dishwashers, freezers or garbage disposals. The 12 AWG conductors are rated for 20 A while the NEMA 5-15 plug is rated for 15 A at 110 V, 115 V or 120 V. The jump is worth it when the original cord is frayed, too short or lacks the temperature rating needed for the installation.

Suits installers and DIY builders needing a pigtail

It suits anyone who must terminate the free end inside a junction box, controller or custom enclosure. Buyers who need a ready-made IEC or NEMA connector on both ends should look at a different cord. Users requiring a higher plug rating than 15 A or a voltage above 120 V will also need another solution.

Highlights

  • Six-foot length reaches appliances without strain
  • 12 AWG copper conductors handle 20 amp loads safely
  • NEMA 5-15P plug fits standard 110/115/120 V outlets
  • UL-approved SJT jacket rated 300 V, 105 °C, VW-1
  • Pre-stripped bare end speeds DIY wiring and repairs

Specifications

No published specifications for this item yet.

Questions about this item

What is the outer diameter of the cord so I can check if it fits my strain-relief clamp?

The cord measures 0.46 in diameter, so verify your clamp or knockout accepts that size before installing.

How do I connect the bare-end wires to my appliance terminals, and what mistake should I avoid?

Strip the pre-stripped leads further if needed, then attach line, neutral and ground to the matching terminals; the common error is reversing line and neutral on a 120 V circuit.

The plug is rated 15 A but the wire is rated 20 A — which limit governs replacement intervals?

The NEMA 5-15P plug caps the assembly at 15 A, so inspect the plug blades and cord jacket annually and replace the cord if the plug shows overheating or the insulation cracks.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.