We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
White 2M cable with XH2.54 4-pin to XH2.0 6-pin connectors

TAURKENAM

TAURKENAM 2M XH2.54 4-pin to XH2.0 6-pin motor cable power adapter

SKU CH-NJ12-B34MK

Connects a 3D-printer stepper motor via XH2.54 4-pin to XH2.0 6-pin terminals over a 2.0 m length

  • 2 metre reach lets you position stepper motors away from the controller board
  • XH2.54 4-pin to XH2.0 6-pin connector bridges two common 3D-printer headers
  • Four cables in one pack provide spares or multi-axis wiring in a single purchase
  • White female terminals give clear polarity identification during assembly
  • Lightweight 2 m wires add minimal mass to moving gantry components

3D printer motor adapter cable

This cable connects a stepper motor with an XH2.54 4-pin plug to a controller using an XH2.0 6-pin socket. It is intended for hobbyists and technicians building or repairing desktop 3D printers who need a longer reach between motor and board.

Two-metre flexible extension for continuous motion

At 2 metres or 6.56 feet the wire gives ample slack for moving gantries without pulling on the board header. The lightweight construction reduces drag during repeated axis travel and the white terminal housings resist vibration loosening over long print jobs.

Plug-in installation with polarity care required

Both ends are keyed female connectors so the cable pushes straight on without tools; however the 4-pin to 6-pin change means only four conductors carry signal — verify the controller pin-out before powering up to avoid crossed phases.

Highlights

  • 2 metre reach lets you position stepper motors away from the controller board
  • XH2.54 4-pin to XH2.0 6-pin connector bridges two common 3D-printer headers
  • Four cables in one pack provide spares or multi-axis wiring in a single purchase
  • White female terminals give clear polarity identification during assembly
  • Lightweight 2 m wires add minimal mass to moving gantry components

Specifications

No published specifications for this item yet.

Questions about this item

Does the 2.54 mm pitch connector generate heat during continuous 3D printer operation?

No, this passive cable assembly has no active components and carries only the stepper motor current supplied by the printer board.

What printer hardware must already have XH 2.0 and XH 2.54 headers for this cable to plug in?

The control board needs an XH 2.54 4-pin header and the stepper motor needs an XH 2.0 6-pin header, both female white terminals.

Will the 6.56 ft length reach a stepper motor mounted on a large-frame printer without strain?

At 2 metres the cable spans most Cartesian and CoreXY frames; route it with slack near moving axes to avoid tension on the connectors.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.