We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two black steel 1U brackets, 19.29 inches wide, folded vertical mount, pack of two

TAURKENAM

TAURKENAM 1U Vertical Wall Mount Server Rack Foldable Patch Panel Bracket 19 inch Pack of 2

SKU CH-5F6E-3ZN42

Two 1U foldable brackets hold 19 inch gear vertically on a wall or horizontally under a desk with 16 and 18.3 inch stud spacing and a 35 pound load rating

  • Supports standard 19-inch rack equipment
  • Foldable 1U design saves space when not in use
  • Two mounting patterns: 16-inch or 18.3-inch centres
  • Cold-rolled steel with black powder coat holds 35 lb
  • Mount vertically on wall or horizontally under desk

1U Vertical Wall Mount Bracket Pack

This pack contains two foldable brackets that accept standard 19-inch rack equipment. Each unit occupies a single rack unit and can be mounted vertically on a wall or horizontally under a desk. The cold rolled steel construction with black powder coating suits small network closets, home labs or edge deployments where floor space is limited.

Thermals Noise and Power Draw

Passive steel brackets generate no heat, emit no noise and draw no power. Thermal management depends entirely on the active equipment installed inside the 2.32-inch depth. The open-frame design allows unrestricted airflow around mounted devices, so cooling performance matches the installed hardware's own requirements.

Replaces Floor Standing Racks for Light Loads

These brackets replace a floor-standing cabinet when the total installed weight stays at or below 35 pounds. The jump is worth it when you need to reclaim floor area and can anchor into 16-inch or 18.3-inch stud spacing. They are not for installations that exceed the weight limit, require lockable enclosures or need deeper mounting bays for full-length servers.

Highlights

  • Supports standard 19-inch rack equipment
  • Foldable 1U design saves space when not in use
  • Two mounting patterns: 16-inch or 18.3-inch centres
  • Cold-rolled steel with black powder coat holds 35 lb
  • Mount vertically on wall or horizontally under desk

Specifications

No published specifications for this item yet.

Questions about this item

How do I choose between the 16-inch and 18.3-inch mounting hole distances when installing this bracket?

Use the 16-inch centres to hit standard wall studs for typical loads; switch to the 18.3-inch centres only when you need the full 35-pound capacity and can anchor into heavier structure.

Will the black powder coating on the cold-rolled steel need any upkeep?

The coating is a durable factory finish; no routine maintenance is required beyond occasional dusting, and it is not designed to be refinished.

At what point does the 35-pound load limit become the restricting factor during continuous use?

The 35-pound rating is the maximum static capacity; exceeding it risks permanent deformation of the 2.32-inch deep bracket, so total mounted equipment weight must stay at or below that figure.

New to this? Buying server hardware with crypto — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.