We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Square 92mm PWM case fan black plastic frame four wire connector dual ball bearing

SXDOOL

SXDOOL T92T13MS2B7-57 92mm PWM case fan

SKU CH-JXT2-ESMTD MPN T92T13MS2B7-57

92 mm dual-ball-bearing PWM fan for Epson projectors including EH-TW5810C and TW6500C

  • Dual ball bearing extends service life
  • 13 V PWM enables precise speed control
  • 92 mm square fits standard mounting holes
  • 25 mm thickness matches common chassis clearance
  • Compatible with listed Epson projector models

92 mm PWM case fan for Epson projectors

The SXDOOL T92T13MS2B7-57 is a 92 mm square frame fan built by Nidec with a dual ball bearing and a four-wire PWM connector. It is intended as a direct replacement cooler for the listed Epson projector models where the original fan has failed or become noisy.

Check voltage and mounting before ordering

The unit runs at 13 V and measures 92 mm by 92 mm by 25 mm, so the projector chassis must accept that exact footprint and supply the matching voltage rail. Verify that the existing fan uses a four-wire PWM header and that the screw-hole pattern aligns with the 92 mm standard used in the target Epson models.

Dual ball bearing and fixed 13 V PWM operation

The dual ball bearing is rated for continuous duty inside the projector enclosure and resists dust ingress better than sleeve alternatives. A four-wire PWM lead allows the projector’s thermal controller to modulate speed automatically, while the fixed 13 V input means no external adapter or voltage converter is required during installation.

Highlights

  • Dual ball bearing extends service life
  • 13 V PWM enables precise speed control
  • 92 mm square fits standard mounting holes
  • 25 mm thickness matches common chassis clearance
  • Compatible with listed Epson projector models

Specifications

No published specifications for this item yet.

Questions about this item

Does the fan ship with mounting screws or a PWM cable, or must I buy them separately?

The unit is supplied as the bare 92 mm × 92 mm × 25 mm fan with a 4-wire PWM lead attached; mounting screws are not included and must be sourced separately.

The listing references several Epson projector models — how do I confirm which one matches my unit?

Check the projector’s service label for EH-TW5810C, TW6500C, CB-680Wi, CB-685W, CB-685Wi, EB-CS500XN, EB-CS510XN or EB-C1000X; the fan’s J33 designation and 13 V rating are specific to those models.

What does the 13 V PWM rating mean for speed control once the fan is installed in the projector?

The 4-wire PWM interface accepts a 13 V control signal, allowing the projector’s thermal controller to vary fan speed precisely across the operating range without voltage drops.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.