We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small black graphics card cooling fan with two-pin connector

SXDOOL

SXDOOL S124010DM VGA Cooling 12V .08A .15A 2-pin

SKU CH-EPRJ-FBAQ2 MPN S124010DM

A 12 V graphics card fan drawing 0.08 A or 0.15 A with a two-pin connector

  • Runs on standard 12V graphics-card power
  • Low 0.08A draw at minimum speed
  • Higher 0.15A available for demanding loads
  • Simple two-pin connector fits existing headers
  • Direct replacement for S124010DM model

Replacement graphics-card fan

The SXDOOL S124010DM is a direct-replacement cooler for graphics cards that use a 12 V two-pin connector. It draws either .08 A or .15 A depending on speed setting, matching the electrical profile of many OEM fans. Installers can swap the unit without rewiring the card's power header.

Upgrade from noisy or failed OEM cooler

This fan replaces an original cooler that has become loud, developed bearing rattle or stopped spinning entirely. The jump is worth it when the card still performs well but thermals throttle clocks or the noise level disrupts work. No new mounting holes or voltage adapters are required for compatible models.

Steady airflow under continuous load

At 12 V the motor maintains constant rpm during extended gaming or render sessions, avoiding the speed droop seen in worn sleeves. The dual current rating lets the card's fan curve shift between quiet idle and higher airflow without stalling. Heat dissipation stays predictable over hours of sustained load.

Highlights

  • Runs on standard 12V graphics-card power
  • Low 0.08A draw at minimum speed
  • Higher 0.15A available for demanding loads
  • Simple two-pin connector fits existing headers
  • Direct replacement for S124010DM model

Specifications

No published specifications for this item yet.

Questions about this item

What connector does the SXDOOL S124010DM fan use to plug into the graphics card?

It uses a 2-pin plug that carries 12V power at either .08A or .15A depending on the speed setting.

How do I install this fan on my video card, and what step is often missed?

Remove the old cooler, align the screw holes on the S124010DM housing, secure it, then connect the 2-pin plug to the board header — the step many miss is routing the cable so it cannot foul the spinning blades.

What part of this fan will need replacement first and how can I tell?

The sleeve bearing inside the motor wears over time; when you hear a new rattle or the RPM drops below spec at 12V, the fan itself should be swapped.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.