We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two black 86mm four-pin graphics card cooling fans side by side

SXDOOL

SXDOOL PLA09215B12H 12V 0.55A 86mm 4Pin VGA Cooling Fan

SKU CH-KPMZ-0QJN4 MPN PLA09215B12H

Replacement 86 mm four-pin cooler for EVGA GTX 1080 Ti SC cards, 12 V 0.55 A, sold in pairs

  • Designed for EVGA GTX 1080 Ti SC graphics cards
  • Dual-fan pack restores cooling to both slots
  • 12 V, 0.55 A power draw matches original spec
  • 85 mm to 86 mm diameter fits stock mounting holes
  • 4-pin PWM connector enables automatic speed control

Direct Replacement Fan

This two-fan set matches the PLA09215B12H model used on EVGA GTX 1080 Ti SC and Black Edition SC2 graphics cards. It suits owners who need to restore original cooling performance on those specific boards. Buyers with different GPU models or screw-hole patterns should verify compatibility before ordering.

Electrical and Physical Specs

Each unit runs on 12 V power and draws 0.55 A through a 4-pin connector. The frame measures 85 mm to 86 mm in diameter to fit the original shroud. No other voltage, current or connector variants are included in this listing.

Critical Fitment Check

The single specification that decides fit is the exact PLA09215B12H model number combined with screw-hole alignment and plug type. Confirm those details against the existing fan before purchase; a different revision will not mount correctly.

Highlights

  • Designed for EVGA GTX 1080 Ti SC graphics cards
  • Dual-fan pack restores cooling to both slots
  • 12 V, 0.55 A power draw matches original spec
  • 85 mm to 86 mm diameter fits stock mounting holes
  • 4-pin PWM connector enables automatic speed control

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the PLA09215B12H fan on my EVGA GTX 1080 Ti SC and what step is often missed?

Align the screw holes exactly with the heatsink mounts and press the 4-pin connector firmly until it clicks; the step most often missed is verifying the plug orientation matches the board header before tightening screws.

What maintenance will the PLA09215B12H need after months of use?

Clean dust from the 85mm or 86mm blades with compressed air every few months; if bearing noise appears or the 0.55A current draw becomes unstable, replace the fan unit.

What limit appears first when the PLA09215B12H runs at 12V continuously?

The 0.55A current rating sets the thermal ceiling; sustained load can push bearing temperature past design limits before the 4-pin PWM signal reaches maximum duty cycle.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.