We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

SXDOOL

SXDOOL FAL3F24LH 5 cm blower fan 24 V 0.15 A 2-lead

SKU CH-DJ2B-86SHQ

A 5 cm blower fan running on 24 V DC at .15 A with a two-lead connector

  • TypeCase Fan Accessory
  • Runs on standard 24 V DC power
  • Draws only 0.15 A for low consumption
  • Turbo blower design directs focused airflow
  • Two-lead wire simplifies installation

5 cm blower fan for 24 V systems

This 5 cm turbo blower fan runs on 24 V DC and draws 0.15 A through a two-lead connection. It is designed as a case fan accessory for equipment that requires focused airflow in a compact form factor. The blower layout directs air through a narrow outlet rather than dispersing it across a wide area. Builders working with 24 V power rails can integrate it directly without additional voltage conversion.

Sustained operation at rated voltage

Under continuous load the fan maintains its rated 24 V and 0.15 A draw without the current spikes seen in larger axial designs. The blower impeller keeps static pressure steady so airflow remains consistent through restricted ducts or heatsink fins. Thermal performance stays stable because the motor does not ramp up during extended runs. Systems that need predictable cooling over long periods benefit from this steady-state behaviour.

Highlights

  • Runs on standard 24 V DC power
  • Draws only 0.15 A for low consumption
  • Turbo blower design directs focused airflow
  • Two-lead wire simplifies installation

Specifications

TypeCase Fan Accessory

Questions about this item

How much heat does the 24 V blower fan add to the case when it runs continuously?

The fan draws 0.15 A at 24 V, so its steady power draw is low and adds only a small amount of waste heat to the enclosure.

What power connector must my system provide for the 2-lead wire?

A 24 V DC source with a two-pin header or solder points is required; the fan has no PWM or tachometer leads.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.