We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Square 80 mm ultra-thin 10 mm case fan with black frame and blades, 4-pin PWM connector and 28 cm cable

SXDOOL

SXDOOL EVERFLOW R128010SU 80×80×10 mm 4-pin PWM case fan

SKU CH-RSBW-EMHNS

An 80 mm ultra-thin case fan with hydraulic bearing, 4-pin PWM control and 1500-4400 rpm speed range

  • PWM speed control from 1500 to 4400 rpm
  • Hydraulic bearing runs quietly at 0.28 A typical draw
  • Ultra-thin 10 mm frame fits tight ITX builds
  • 28 cm cable reaches motherboard 4-pin header easily
  • Blade stays inside 80 mm frame for safe clearance

Ultra-thin 80 mm case fan

The SXDOOL EVERFLOW R128010SU is an 80×80×10 mm case fan built for compact chassis and ITX builds where vertical space is tight. It targets system builders who need active cooling in small-form-factor enclosures without exceeding the frame height.

Hydraulic bearing and 4-pin PWM control

A hydraulic (EBR) bearing supports a speed range of 1500–4400 rpm ±5 % at 12 V DC, drawing 0.35 A rated and approximately 0.28 A measured. The 4-wire PWM connector plugs directly into a standard motherboard 4-pin header, and the 28 cm lead reaches most ITX board fan headers without strain.

Clearance and header checks before ordering

Verify that your case or heatsink can accommodate a 10 mm thick fan at the intended mount points. Confirm the motherboard provides a 4-pin PWM header at the correct voltage; 3-pin headers will run the fan at full speed without speed regulation.

Highlights

  • PWM speed control from 1500 to 4400 rpm
  • Hydraulic bearing runs quietly at 0.28 A typical draw
  • Ultra-thin 10 mm frame fits tight ITX builds
  • 28 cm cable reaches motherboard 4-pin header easily
  • Blade stays inside 80 mm frame for safe clearance

Specifications

No published specifications for this item yet.

Questions about this item

Does the 4-pin PWM connector let the motherboard control the fan down to 1500 rpm?

Yes, the 4-pin PWM header allows the motherboard to vary speed between 1500 and 4400 rpm with a +5 % tolerance.

Will this 80 mm × 80 mm × 10 mm frame fit a standard 80 mm fan mount?

The 80 mm square frame and 10 mm thickness match the common 80 mm mounting pattern, so it fits standard 80 mm case or radiator holes.

How do I plug in the 28 cm lead without putting strain on the motherboard header?

Route the 28 cm cable so it reaches the 4-pin header with slack, then press the connector straight on — forcing it at an angle bends the pins.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.