We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Square black plastic frame fan with red and black bare wires

SXDOOL

SXDOOL AGE07025B12H 70x70x25mm 12V .40A Ball Bearing Red/Black Bare Leads 21cm case fan

SKU CH-SPGV-MWN7Z

A 70 mm square case fan spinning at 4900 RPM with a ball bearing, 12 V .40 A draw and 21 cm bare leads

  • 12 V DC 0.40 A ball bearing for reliable equipment cooling
  • 70 × 70 × 25 mm frame fits standard mounting points
  • 4900 RPM speed delivers strong airflow for thermal management
  • Red black 2-wire bare leads 21 cm allow flexible wiring
  • Exact model AGE07025B12H verified on label for correct replacement

SXDOOL 70mm ball-bearing case fan

The SXDOOL AGE07025B12H is a 12V DC axial fan with a 70x70x25mm frame and ball-bearing construction. It spins at 4900 RPM and draws 0.40A from a two-wire bare-lead harness approximately 21cm long. This single unit suits equipment-cooling assemblies that require the exact model, voltage and dimensions shown on the label.

Replacing a worn 70mm axial fan

Install this fan when the original AGE07025B12H or an identical 12V 0.40A ball-bearing unit has failed or become noisy. The jump is worth it only if the mounting holes, frame thickness, wire count and lead length match the original specification; otherwise the fan will not fit or connect. Verify every parameter on the old label before ordering.

Limits of bare-lead 12V DC connection

The red and black leads carry power only, with no tachometer or PWM wire, so the motherboard or controller cannot monitor speed or adjust it automatically. Polarity is not marked on the leads, so incorrect wiring will prevent operation. The 21cm length may fall short in larger enclosures, and the lack of a standard connector means soldering or crimping is required for most PC builds.

Highlights

  • 12 V DC 0.40 A ball bearing for reliable equipment cooling
  • 70 × 70 × 25 mm frame fits standard mounting points
  • 4900 RPM speed delivers strong airflow for thermal management
  • Red black 2-wire bare leads 21 cm allow flexible wiring
  • Exact model AGE07025B12H verified on label for correct replacement

Specifications

No published specifications for this item yet.

Questions about this item

Will the 70 x 70 mm frame with 25 mm thickness line up with my existing screw holes?

The frame measures 70 mm by 70 mm and is 25 mm thick; match these dimensions and the hole pattern to your chassis or heatsink before fitting.

How do I connect the red and black bare leads safely?

Identify the positive and negative pins on your 12 V header, strip the 21 cm leads if needed, then solder or crimp them to the correct polarity before powering on.

When should I expect to replace the ball-bearing fan?

Ball bearings typically run for tens of thousands of hours at 4900 RPM; listen for new noise or vibration as the signal to swap it out.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.