We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two small black 35mm fans with triangular 25/26/27mm mounting holes and short two-wire leads

SXDOOL

SXDOOL 4010 35mm graphics card fan blade 25/26/27mm pitch 12V 2-pin

SKU CH-YBV8-K91CM

Replacement 35 mm fan blade with 25, 26 or 27 mm pitch for 12 V graphics card coolers

  • Fan Size35mm
  • Ultra-quiet operation backed by 3200 rpm speed
  • Precise GPU fit with 25/26/27 mm hole pitch
  • Reliable 12 V power via 2-pin connector
  • Compact 35 mm blade for tight clearance
  • Low 0.1 A draw keeps system power efficient

Replacement 4010 Graphics-Card Fan

This 35 mm 4010 fan is built as a direct drop-in replacement for graphics cards that use a 35 mm diameter rotor. It suits repair technicians and enthusiasts who need to restore cooling on a card whose original blower has failed or become noisy.

Equilateral-Triangle Mount with 2-Pin Lead

The mounting holes sit on a 25/26/27 mm equilateral-triangle pitch, matching the pattern found on many reference-style coolers. A two-pin needle connector on a 7 cm lead plugs straight onto the card’s fan header without adapters or soldering.

3200 RPM at 12 V and 0.1 A Draw

Rated at 3200 rpm on 12 V DC, the fan draws only 0.1 A while moving air through the heatsink. The low current keeps the card’s fan-controller margins wide, and the ultra-quiet bearing design minimises audible noise during typical gaming or compute loads.

Highlights

  • Ultra-quiet operation backed by 3200 rpm speed
  • Precise GPU fit with 25/26/27 mm hole pitch
  • Reliable 12 V power via 2-pin connector
  • Compact 35 mm blade for tight clearance
  • Low 0.1 A draw keeps system power efficient

Specifications

BrandSANYO DENKI
Fan Size35mm

Questions about this item

What does the 2-pin 7 cm needle connector limit on this 12 V fan?

The two-pin needle connector supplies 12 V DC at up to 0.6 A without PWM control, so speed is fixed at the rated 3200 rpm.

Will the 25/26/27 mm equilateral-triangle screw pattern match my GPU shroud?

The blade mounts on holes spaced 25 mm, 26 mm or 27 mm apart in an equilateral triangle; measure your shroud to confirm one of those pitches.

How do I fit the 35 mm blade onto the motor hub without stripping the tiny screws?

Align the blade centre with the motor shaft, start each of the three screws by hand, then tighten evenly in a cross pattern to avoid binding.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.