Peerless Industrial Group
Peerless Industrial Group Tire Chains Single Bus & RV V-Bar PK2 QG2821
$67.99
0.00082009BTC
In stock
Steelman
Steelman 60157 Torque Socket Extension 10 in Red
A 10-inch alloy-steel torque socket extension rated for 250 ft-lb and 338 N-m, designed for 3/4-inch drive impact wrenches
- ColorRed
- 3/4 in drive fits impact wrenches
- 250 ft-lb working torque handles heavy lugs
- 10 in overall length reaches recessed bolts
- Alloy steel construction resists high-stress use
- Red finish identifies the tool quickly
3/4-Inch Drive Torque Extension
The Steelman 60157 is a 10-inch torque socket extension built from alloy steel for use with impact wrenches. Its 3/4-inch drive size fits heavy-duty automotive and industrial fasteners. The red finish aids quick identification in a busy workshop. Rated for 250 ft-lb or 338 N-m of working torque, it suits high-torque wheel and suspension jobs.
Replaces Shorter Or Worn Extensions
Swap this in when a standard extension is too short to reach recessed lug nuts or when an older bar shows twist or cracking. The 10-inch reach clears deep wheels without adding a universal joint that can reduce torque accuracy. Upgrade is worth it whenever the current tool cannot deliver the full 250 ft-lb rating to the fastener.
Impact-Wrench Interface Limits
The 3/4-inch square drive limits use to impact wrenches and ratchets with matching anvil size; it will not fit 1/2-inch or 1-inch tools without an adapter that adds length and potential failure points. Alloy steel handles the rated torque but cannot compensate for excessive hammering beyond 250 ft-lb. Always verify the wrench output stays within the 338 N-m working limit.
Highlights
- 3/4 in drive fits impact wrenches
- 250 ft-lb working torque handles heavy lugs
- 10 in overall length reaches recessed bolts
- Alloy steel construction resists high-stress use
- Red finish identifies the tool quickly
Specifications
| Brand | STEELMAN |
|---|---|
| Color | Red |
Questions about this item
What drive size does the 10 in Steelman 60157 extension fit?
The extension has a 3/4 in drive size on both ends so it connects directly to a 3/4 in impact wrench and a 3/4 in socket.
How do I install the extension without rounding the corners?
Seat the square drive fully into the wrench anvil until the detent ball clicks, then engage the socket the same way; the common mistake is leaving a gap that lets the drive slip under load.
When should I replace this 250 ft-lb alloy-steel extension?
Replace it if the square drive shows cracks, the detent ball no longer holds, or the red coating wears through to bare steel indicating possible fatigue.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
