We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two small rectangular network adapters with RJ45 ports and LED indicators, wall-mountable, power adapters included

STARTECH

STARTECH 10/100 Ethernet Extender Kit 0.5mi adapter

SKU CH-W0FT-QBGQY

Extends 10/100 Ethernet to 800 m over UTP with VLAN tag and jumbo-frame support

  • Extends Ethernet to .5mi (800m) beyond the standard 328ft limit
  • Delivers 100Mbps up to 984ft on single-pair and 10Mbps to 2624ft on two-pair
  • Passes VLAN tags, 16K jumbo frames, WoL and PXE transparently
  • DIP-switch configuration with LED status for power, link, speed and LFPT
  • Includes power adapters for local and remote units, wall or surface mount

Long-Range Ethernet Extender Kit

This StarTech kit extends a 10/100 Ethernet link up to 0.5mi (800m) over a single twisted pair or standard UTP cable. It is built for installers and IT teams who need to reach remote cameras, access points, sensors or VoIP endpoints far beyond the normal cable run limit.

Distance and Speed Trade-Offs

The standard 100m (328ft) Ethernet limit is replaced by two operating modes: a single pair delivers 100Mbps up to 300m (984ft), while two pairs drop the rate to 10Mbps but reach the full 800m (2624ft). Bandwidth and distance are therefore mutually constrained by the cabling choice.

Capacity and Protocol Headroom

The transparent bridge passes IEEE 802.1q VLAN tags, Wake-on-LAN, 16K jumbo frames and PXE boot traffic without modification. It handles typical surveillance, automation and voice loads comfortably, but the 10/100Mbps ceiling means it cannot serve gigabit uplinks or high-throughput storage traffic.

Highlights

  • Extends Ethernet to .5mi (800m) beyond the standard 328ft limit
  • Delivers 100Mbps up to 984ft on single-pair and 10Mbps to 2624ft on two-pair
  • Passes VLAN tags, 16K jumbo frames, WoL and PXE transparently
  • DIP-switch configuration with LED status for power, link, speed and LFPT
  • Includes power adapters for local and remote units, wall or surface mount

Specifications

No published specifications for this item yet.

Questions about this item

Should I use one pair or two pairs of cable for my run?

One pair reaches 300m at 100Mbps; two pairs reach 800m at 10Mbps. Choose the shorter distance if you need the higher speed.

What does the 10/100Mbps rating mean once the extender is installed?

The link negotiates at either 10Mbps or 100Mbps depending on cable length and pair count; jumbo frames up to 16K pass through transparently.

Which Ethernet standard does the kit follow and what distance does it cap?

It follows IEEE 802.1 and extends the usual 328ft limit to 984ft at 100Mbps on one pair or 2624ft at 10Mbps on two pairs.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.